Web Results


Smoke detectors usually last 10 years, so if yours is older than that, you’ll need to replace it. Check the manufacture date printed on the smoke detector to see how old it is.. If your smoke detector is relatively new, you may need to have a professional inspect it to see why it’s malfunctioning. A professional can make sure your detector is working properly, and install a new one if it ...


How Do You Stop a Hard Wired Smoke Alarm From Chirping? In most cases chirping hard-wired smoke alarms can be stopped by pressing and holding the reset button. Wait a few minutes to see if the chirping stops.


If you have changed the battery in your chirping smoke detector and it still chirps, you might think your detector is bad. Before you replace that smoke detector or go out and purchase another new pack of nine-volt batteries, there are a couple things you should know about your smoke detector, and a few things […]


.1 Battery Backup Is Low/Removed .2 Alarm is Older then 5 or 10 Years .3 Loose Wiring .4 Dust in Alarm


If you hear your smoke detector beeping, you should properly check your detector to ensure its functioning properly. The information below will help you to determine the reason your detector is beeping and how you can correct the issue. If Your Detector is Hard-Wired. The reasons why a smoke detector beeps depend on the smoke detector's design.


A beeping smoke detector gets on your nerves quickly, but that noisy alarm may be trying to tell you something. Detectors often beep or chirp when something isn't right. The issue could be anything from a dying battery to a malfunction in the alarm's components. It's even more frustrating that you can't always tell which detector is making the sound.


Another reason for a smoke alarm beeping is that it has reached the end of its lifetime. Smoke alarms usually last for between eight and ten years. Take the smoke alarm off and check the date of manufacturing on the back. If it is more than eight years old, you would need to replace the smoke alarm as soon as possible.


What is causing my smoke alarm to sound, beep, or chirp? Aug 13, 2015. Loud continuous alarming. When the smoke alarm detects combustible products and goes into alarm mode, the pulsating alarm will continue until the air has cleared. For procedures on what to do when your alarm is in active alarm mode, go to What to do When Your Smoke Alarm Sounds.


It is good practice to clean the smoke alarm when you change the battery. Static electricity from the ac quick connector attracts dust and can cause false alarms. To clean your smoke alarm, perform the following steps: Remove your alarm from the mounting bracket as outlined in How to Remove Your Smoke Alarm.


False Fire Alarms Instead of beeping, you may have a smoke detector going into alarm for no reason. False fire alarms like this can have many causes, but here are a few of the most common. Dirty Smoke Detectors. Even the cleanest homes can have dust, and it is one of the biggest causes of smoke detector problems.