The presence of water in a vehicle's fuel system can present several problems including the alteration of fuel to air ratio that will reduce engine power that may cause the engine to stall. If large amounts of water enters a vehicle's fuel system, it can lead to prolonged cranking, stalling and a lo
When condensation from water contaminates a gas tank, the most common symptoms are poor fuel economy, engine running rough, stalling or failing to start, and hydrostatic lock. Condensation inside a fuel tank or a leaky fuel filter can contaminate gas that has been stored too long.
A hot water tank heater works by the principle of convection where heated hot water rises and cold water is lowered to take its place before being heated. Gas is used to heat the water at the bottom of the tank.
To clean a gas tank, set an approved gas container on the ground, assemble a siphon, insert one end of the hose into the gas tank and one in the gas container, pump the siphon handle, and withdraw the hose. This 10-minute procedure requires a gas container, a screwdriver and a manual siphon.
While a small amount of oil, diluted with a full tank of gasoline, does not harm the engine, it is not wise to add oil to a gas tank. Too much oil can do significant harm to the fuel system.
Because the particles are not soluble in gasoline, putting anything grainy like salt or sugar is bad for the fuel tank, various filtration systems and fuel pumps. Adding salt clogs and corrodes these parts, requiring intensive cleaning and replacement.
Sugar does not dissolve in gasoline, so pouring sugar into a gas tank could clog up the filter of the car. If enough sugar is poured into the gas, it could disable the car, although this does not always happen. Pouring sand into a gas tank could have the same effect.
The average capacity of a vehicle's gas tank is typically listed on the owner's manual of that specific make and model. However, in most cases, the listed number is an estimate and tends to vary from the actual capacity of the fuel tank.
Gas tank capacity refers to the amount of fuel that a vehicle's gas tank can hold. The gas tank capacity of a particular vehicle can usually be found in the owner's manual.
When using a fuel tank cleaner, first remove the tank and drain all of its fuel, and then clean any accumulated debris or rust that may be present on top of the fuel tank or its assembly. Remove the tank's lock ring, remove its hanger assembly, and flush the tank with high-pressure water mixed with