http://blog.wiseco.com/everything-you-need-to-know-about-ring-gap

Jul 6, 2018 ... Setting the correct ring gap on aftermarket piston rings is crucial for proper .... with Nitrous/Turbo - 0.006in x 4.00in bore = 0.024 inch ring gap ...

http://www.wiseco.com/PDFs/Manuals/RingEndGap.pdf

Use the piston to square up the ring in the bore, and check the end gap by using a feeler gage. 3. See table ... Street-Moderate Turbo / Nitrous .0050” .0055”.

http://www.engineprofessional.com/TB/TB011117-2.pdf

Drop in ring sets typically require no adjustment to end gaps, but MAHLE ... Turbo /Supercharged up to 15 lbs Bore x 0.0060" Bore x 0.0050" Min 0.015".

http://www.totalseal.com/pdf/GAPCHART.pdf

TOTAL SEAL RECOMMENDED GAP CHART. APPLICATION. Street, strip, circle. Nitrous up to 150HP. Nitrous 150HP-350HP. Nitrous 350HP+. Mild boost up to ...

https://www.youtube.com/watch?v=uAguO3EPzcI

Nov 16, 2016 ... Check out Kalvinator Engines: http://www.kalvinatorengines.com Piston ring gap is critical to the operation of your engine. Especially if it's a ...

https://www.onallcylinders.com/2015/07/16/gap-rap-how-to-measure-and-set-piston-ring-end-gap/

Jul 16, 2015 ... Most folks say the gaps on the second ring are driven more by the cylinder bore diameter. Adding nitrous or boost (turbo or supercharged), ...

https://www.hastingspistonrings.com/tech-tips-faqs/checking-compression-ring-gaps

Feb 19, 2015 ... Ring gaps are often a confusing and misunderstood part of a re-ring job. There are MINIMUM and MAXIMUM ring gap specifications,which ...

https://www.enginelabs.com/engine-tech/blueprint-series-the-how-and-why-of-setting-piston-ring-end-gap/

Oct 16, 2018 ... For a 4.00-inch bore piston, this is a top ring end gap of 0.028-inch. ... However, if nitrous or a serious turbo boost package was in this engine's ...

https://store.schnitzracing.com/piston-ring-end-gap-chart/

Ring end gap should be measured with the ring square in the bore on a fresh hone. Cylinder should ... Turbo/Supercharged .006" x Bore .006" x Bore, Min .015 ".

http://www.badasscars.com/index.cfm/page/ptype=product/product_id=393/prd393.htm

And then should the 2nd ring gap be bigger or smaller than the top? ... too far and butt together or they will break, or possibly even break the top of the piston off!