Web Results

www.familyhandyman.com/project/how-to-splice-automotive-wires

Strip the insulation so only the bare wire is inside the connector. Then make a single 5/16-in. crimp on each side of the butt connector. Cut a section of moisture sealant to cover the entire connector and a 1/2-in. overlap on each end. Then double it over and squeeze it together with your ...

www.knowyourparts.com/technical-resources/electrical/splice-wires-hand

Step 2: Holding a wire in each hand, take the “Y” and interlock the two wires together. But, leave room between the two “Y”’s large enough for the outer insulation from the “none” strip section of wire to easily pass through. Lay the “Y” sections down along the wire without bending them backward, straight and even with the wire.

www.avsforum.com/threads/can-i-splice-two-cooling-fans-wires-together.1605433

can I splice two cooling fans wires together then plug into one three pin connecter? I'm trying to install two intake cooling fans in my new case however I only have one three pin connecter on the front of case. I actualley order a Y-adaptor was planning on having two exhaust fans however...

www.popularmechanics.com/cars/a1430/4213013

The most secure and durable way to splice two wires together is to solder them. Period. Use nothing but 60-40 rosin-core solder intended for electrical wiring. You'll also need some PVC shrink tube.

www.ehow.com/how_8591155_splice-62-electrical-wire.html

Insert one wire in each end of the insulated set screw butt splice. Tighten the two screws on the connection mechanism. Repeat this process to connect the other two wires. Step 5 Secure the electrical box's access door with the screws provided. Mount the box in a place that is both accessible and in a location that reduces the chances of ...

www.toyotanation.com/threads/how-to-splice-2-wires-into-1.400050

I work on generators for a living and you can buy connectors that splice 2 wires together. All you need to do is strip the 2 wires, twist them around each other and then crimp them to the connector. If you cant find that connector, you might also try using a wire nut or you last resort could be electrical tape.

ask-the-electrician.com/how-to-safely-splice-copper-and-aluminum-electrical...

The wire connectors must be approved for splicing AL/CU wires. Make sure that the wire connectors have a genuine UL Listing symbol. Apply corrosion inhibitor gel to the wires to be spliced together. Make sure that the wires are firmly secure inside the wire connectors. More about Splicing Electrical Wiring. How to Splice Electrical Wires

www.ehow.com/how_8092433_splice-low-voltage-wires.html

Twist the wires of the same polarity together horizontally and smoothly so that the twisted portion is in line with the wiring. Solder the connection so that the solder penetrates the twisted wires. Slide the shrink tubing over the splice. Blow on the shrink tubing with a hair dryer until it has shrunk over the splice.

www.hvacrschool.com/splicing-wires-bad-good-better-best

Splicing any high voltage conductor in an “open” manner or in way that is not specifically rated. In most cases get a UL rated connector and make the connection inside a UL / NEMA rated rated box or assembly. Making a splice by just twisting wires together and putting electrical tape on top. Just don’t.

www.doityourself.com/stry/how-to-splice-an-underground-electrical-wire

Step 5 - Use a Splice Kit. A splice kit containing an inline connector will join the two ends of a break securely in a polyolefin sleeve, which will shrink when heat is applied, to maintain a water-resistant connection. Inside the heat shrinkable tubing is an adhesive liner that will melt when heated.