To reset a Genie Intellicode garage door opener, press the Learn Code button on the garage door opener receiver and the controller, press the button on the controller you wish to program, and test to confirm the connecti... More »

To program a Genie Intellicode garage door opener, press the "Learn Code" button near the remote control's antenna. After the LED light blinks twice, press the button again. The LED either stays lit or starts flashing, d... More »

www.reference.com Home & Garden Doors, Windows, & Locks

To program a remote for a Genie garage door, first press the "learn code" button on the back of the garage opener unit, then press the button on the remote twice. An LED light on the main unit will indicate if the remote... More »

To program a Genie garage door opener, find the Learn Code button on the door opener, press and release the Learn Code button, and once the LED light blinks, press and release the button on the remote that you want to pr... More »

www.reference.com Home & Garden Outdoor

To program a Genie Intellicode garage door opener, press the "Learn Code" button near the remote control's antenna. After the LED light blinks twice, press the button again. The LED either stays lit or starts flashing, d... More »

www.reference.com Home & Garden Doors, Windows, & Locks

To set up a Stanley garage door opener, put the drive motor unit of the Stanley garage door opener in program mode, select a button on the remote, and hold it down until it is accepted. These instructions work for both t... More »

Press the "Learn Code" button on the garage opener unit while at the same time pressing the button on the remote that is to be programmed into the opener. The lights on both units should flash, or light up and remain sol... More »

www.reference.com Home & Garden Outdoor