http://blog.wiseco.com/everything-you-need-to-know-about-ring-gap

Jul 6, 2018 ... Setting the correct ring gap on aftermarket piston rings is crucial for .... each ring will need and get closer to the finished spec in fewer steps.

http://blog.wiseco.com/how-to-file-fit-and-install-piston-rings

Dec 25, 2017 ... An in-depth look at how to file-fit and correctly install piston rings for ... to run ring end gaps smaller than the recommended spec (included with ...

https://www.hastingspistonrings.com/tech-tips-faqs/checking-compression-ring-gaps

Feb 19, 2015 ... Ring gaps are often a confusing and misunderstood part of a re-ring job. There are MINIMUM and MAXIMUM ring gap specifications,which ...

https://www.youtube.com/watch?v=uAguO3EPzcI

Nov 16, 2016 ... Check out Kalvinator Engines: http://www.kalvinatorengines.com Piston ring gap is critical to the operation of your engine. Especially if it's a ...

https://www.aa1car.com/library/ring_end_gap.htm

Checking and adjusting the end gaps of the pistons rings is necessary when new rings or pistons are installed in an engine. The proper end gap assures a good ...

https://www.onallcylinders.com/2015/07/16/gap-rap-how-to-measure-and-set-piston-ring-end-gap/

Jul 16, 2015 ... Gap Rap: How to Measure and Set Piston Ring End Gap ... looser, but that depends on the ring configuration and the manufacturer specs.

https://www.jepistons.com/PDFs/TechCorner/SCPDrawings/piston_instrc4032.pdf

Piston to cylinder wall clearance. 1. Piston diameter must be measured at gauge point which, in most cases, is .500" up from the bottom of skirt. (See fig. 1).

https://www.cp-carrillo.com/file/6852-Piston+%26+Ring+Installation.pdf

Due to the nature of high performance applications, CP Pistons/Pankl products are sold without ... Failure to check ring gap can result in severe engine failure.

https://www.enginelabs.com/engine-tech/blueprint-series-the-how-and-why-of-setting-piston-ring-end-gap/

Oct 16, 2018 ... The KB spec is 0.0065-inch per inch for a street engine. For a 4.00-inch bore piston, this is a top ring end gap of 0.028-inch. For mild nitrous, the ...

https://store.schnitzracing.com/piston-ring-end-gap-chart/

Ring end gap should be measured with the ring square in the bore on a fresh hone. Cylinder should be free of any taper. Use this chart to determine the proper  ...