Web Results

hyperphysics.phy-astr.gsu.edu/hbase/Music/flute.html

The flute is made in the form of an open cylindrical air column about 66 cm long. Its fundamental pitch is middle C (C4) and it has a range of about three octaves to C7. Sound is produced from a flute by blowing onto a sharp edge, causing air enclosed in a tube to vibrate.The flute as shown above is a transverse or side-blown flute.

newt.phys.unsw.edu.au/jw/fluteacoustics.html

The flute is an open pipe The flute is open at both ends. It's obvious that it's open at the far end. If you look closely at someone playing a flute, you'll see that, although player's lower lip covers part of the embouchure hole, s/he leaves a large part of the hole open to the atmosphere, as shown in the sketch above.

astro.pas.rochester.edu/~aquillen/phy103/Lectures/I_Flute.pdf

Flute Physics . 2 Normal modes of a column No motions, large pressure variations No pressure variation, large motions . 3 Is the flute -an open column -a closed column or -one end open and other end closed? How can we find out? 4 Experiments on the open pipe • Blocking the end ...

prezi.com/doy70av6zgin/pan-flute-physics

To increase the range of notes that can be played on the flute, a process known as overblowing may be used. By increasing the velocity of the air stream at the embouchure, the player can increase the speed of the vibrations in the tube to point where the column of air cannot

www.youtube.com/watch?v=AcZipcoOxUg

A school project on the physics behind the flute Please try to ignore the background noise :(

prezi.com/anf1tgabbon7/physics-of-the-flute

If you open the tune holes, you make the pressure node move closer up the pipe, making the pipe shorter- acts like a short circuit to the outside air "Flute Acoustics: An Introduction." Flute Acoustics: An Introduction. N.p., n.d. Web. 19 Nov. 2013. "Flute." Wikipedia. Wikimedia

answers.yahoo.com/question/index?qid=20121114190555AA2LWxA

I have a physics assignment where I need to make a Pan Flute and understand its frequency, wavelengths, harmonics, speed of sound, the lengths of the mediums, pitches, etc. Does anyone know a good site to explain to me the equations and steps I need to take to do this? Or can you help me out on how to get this information?

interactives.ck12.org/simulations/physics/pan-flute/app/index.html

Learn about wave harmonics in a column of air by looking closely at the sound produced by a pan flute using our interactive simulation.

newt.phys.unsw.edu.au/music/flute

Flute Acoustics A site dedicated to understanding the flute. Where to start. Introduction to flute acoustics is just that, and a good place to start. If you can't remember much about sound, try the introduction of How do woodwind instruments work? If you strike a term or idea you don't know, try the Basics list on the navigation bar.

pages.mtu.edu/~suits/Physicsofmusic.html

The author is B. H. Suits, Physics Department, Michigan Technological University, copyright 1998-2019. There are no pop-ups or ads of any kind on these pages. If you are seeing them, they are being added by a third party without the author's consent.