Web Results


Low voltage wiring is wiring that does not conduct more than a certain voltage, defined in the United Kingdom as below 50 volts alternating current or 120 volts direct current. It thus does not pose the same degree of risk as higher-voltage systems do.


A wire-to-wire connector is a device, usually made of plastic, that is used to join electrical circuits together by creating a joint between two sections of wire. This serves to extend the flow of electricity wherever needed.


Resistance between the voltage source and the load causes a voltage drop in wiring. A poor connection, corrosion, the type of wire being used, the diameter or gauge of the wire, and the distance between the source and the load can all cause resistance in wiring.


Voltage regulator wiring connects the device to a circuit. It consists of one input, one output and one ground wire that attach to a corresponding pin on the regulator. The input wire, connected to the input terminal, receives voltage from the circuit. This voltage is routed through the regulation m


Some common problems in low-voltage lighting include frequent burnouts, corrosion and voltage drop. These problems can be avoided by properly regulating voltage, protecting lights and designing the system properly.


Voltage is the difference of electrical potential between two points or two objects. Without this difference of electrical potential, electricity could not be used as a power source.


The unit for potential energy per unit charge, or voltage, is the volt, which has the symbol "V." It takes its name from the Italian physicist Alessandro Volta, credited with inventing one of the first electric batteries.


Low-voltage transformers are electronic components that convert standard line voltage to a significantly lower output. For instance, these devices transform 120 or 277 volts, which are typical in residential and commercial power applications, to a reduced 12 or 24 volts.


A voltage follower is an op-amp circuit that has a voltage gain of one. It's also referred to as an isolation amplifier, a buffer amplifier and a unity-gain amplifier. The op-amp doesn't provide any amplification to the signal.


The different types of cable connectors include audio, Centronics, D-sub, digital video, DIN, fiber and networking, FireWire, internal, modular, power, SCSI, specialty, USB and video. Depending on the cable, it may be used with computers, televisions, cameras, audio devices or other electronics.