Those wires are now connected to the main switch. Then the hot wire enter the SFU( Switch fuse unit). The load is connected between the switch and ground . Electric potential is applied to the hot wire and at ground it is zero , the load consumes power when th...
What Color Is the Load Wire? In a circuit, the main load wire — the live power wire between the switch and power source — is typically black, and the secondary load wire is usually red. Wire colors can vary between circuits, so it is best to remove or turn off power sources before touching them.
The Load wire is always hot (black or red wire) and the Line wire is the one that returns to your fusebox (usually white). Answer above is absolutely wrong written by someone who does not know ...
The documentation states the switch has specific connections for the "line" wire and the "load" wire. Maybe this is a dumb question, but how can I be sure which is which? Is the "line" wire always going to be the hot wire connected to the top of the switch and the "load" wire the hot one connected to the bottom? What happens if I get it wrong?
# 22 A very quick look at the difference between line and load and how it applies to an endless list of electrical devices. ... How To Wire A Single Pole Light Switch - Duration: 8:57 ...
What does it mean when one wire goes into load, and one goes into line. ... The previous outlet that was there, had the white wire going into the silver load terminal-- while the black wire was going into the brass line terminal. There was only 2 wires connected. ... The "hot" wire(s) connect to the brass screw, neutral to the silver and bare ...
Distinguishing between line and load isn't always necessary. For example, a conventional wall switch -- which is a single-pole, single-throw switch -- works equally well whether you attach the live circuit wire -- line-- to the top brass terminal or the bottom because the switch has only two positions -- open or closed.The terminal connections are directional on a double-throw switch, on the ....
The load wire is the hot wire.the hot side of a breaker is the line side and the other side that goes to a circuit is the load side.The black wire should be the hot,white the neutral and green or bare is the ground.You should read 120 between the black and white.
Reverse polarity (hot and neutral reversed) means neutral wires are connected to the side of the receptacle that is supposed to be for the hots, and vice versa. See Outlet testers and Outlet corrections. What is the difference between Line and Load? For this, see the Glossary.