A homemade flute can be made out of a two-foot section of PVC pipe that is about 3/4 inches in diameter and a tapered rubber stopper of the same diameter. Essentially, the steps involve drilling holes in the pipe and add... More »

Make your own leather conditioner by combining olive oil, vinegar and essential oil in a spray bottle. Shake up the mix, and use it on leather furniture, jackets or car seats. More »

Make homemade grease remover by adding 1 cup of ammonia, 1/2 cup of vinegar and a 1/4 cup of baking soda to a gallon of water. Mix it well and use a cloth to remove grease. Store it in a clean jug with a lid for later us... More »

www.reference.com Home & Garden Cleaning Cleaning Products

To make a corn feeder, place a cap to one end of a 4-foot section of 4-inch PVC pipe, and attach a Y-coupler to the other end of the pipe, using PVC pipe cement to secure it in place. Drill drainage holes in a second cap... More »

www.reference.com Sports & Active Lifestyle Outdoor Adventure

The easiest way to repair a cast iron drain pipe is to remove the bad section of pipe by cutting it away and replacing it with PVC pipe. This makes it easy to repair the pipe without having to replace the whole setup. More »

To make a homemade deer feeder, connect a 3-foot length of 6-inch PVC pipe to a 6-inch wye PVC piece, then cover the top and bottom of the PVC with a cover and attach three eye bolts to the top and either side of the fee... More »

www.reference.com Pets & Animals Mammals Deer

To build a suppressor, start by cutting a 2-inch PVC pipe to a length of 10 inches. Cut a 1-inch PVC pipe to a length of 12 inches. Use a marker and a tape measure to mark out a straight line of evenly spaced dots on the... More »

www.reference.com Home & Garden Home Maintenance Carpentry