Web Results


This gas log set is equipped with an ignition device (piezo) which automatically lights the pilot. If piezo ignitor does not light the pilot, refer to your manual for Match Lighting Instructions . Turn gas control knob clockwise to the OFF position and turn ON/OFF switch to OFF position.


http://trentstone.com/ A short video taking you step-by-step through the process of lighting a set of vent-free gas logs.


Most gas fireplaces have a standing pilot light, which is a small flame that burns even when you aren't using the fireplace. This makes the fireplace easy to start when it's cold outside, but when it warms up, it's a good idea to shut off the pilot to conserve gas.


A step by step instructional video to help you understand and light your pilot light on your gas logs, regardless of type. We are located in Chattanooga Tennessee providing educational videos to ...


Match Light. The Match Light lighting method is the most basic lighting method. It has no pilot valve assembly at all. You place a match or lighter near the log burner and turn on the gas with your existing gas key valve.


Push and hold the knob in for a time sufficient to replace the air in the pilot line with gas (this can sometimes take up to three minutes, as the pilot line is very small, as is the amount of gas flowing to the pilot). While pushing the knob in, light the pilot with a match (or push the button of the piezo ignitor, if equipped).


The next step and how to light a gas fireplace is to find the ignition button. Many new gas log units come with an ignition button. If you don’t have one of these buttons, you may need to light the log with matches once the pilot light is lit. Find the Control Knob


Gas fireplaces are available in both natural-gas and liquid-propane (LP) styles and provide the comfort and warmth of a traditional fireplace without the hassle of chopping wood. Most systems are ...


These logs are ceramic and painted to look like burning wood logs. The combustion of the gas around them still does leave behind a little soot, which typically only needs cleaning on an annual basis. To clean out the gas logs, turn off the fireplace’s pilot light, place the logs onto paper outside the fireplace, then vacuum up the soot.


If the pilot does not light within 45 seconds, turn the on/off switch back to the off position and wait 15 seconds. Repeat this step as necessary until the pilot ignites. NOTE: If the on switch is left on for more than 60 seconds and the pilot does not light the fireplace will go into "lock out" mode.