Web Results


To repair a scratch in the clear coat, first clean the car panel with warm soapy water. For scratches that have only penetrated the clear coat, the scratch can be carefully sanded out. After sanding the clear coating, the scratched area needs to be replaced.


While in many cases the only solution for fixing peeling clear coat on cars is by entirely removing and reapplying the clear coat, very small blemishes can be repaired by slightly scuffing the area for adhesion, then reapplying a few layers of clear coat. However, this is only a suitable solution fo


To remove clear coat from a car, use wet/dry sandpaper, water, rubbing compound, touch-up paint and a dry, soft cloth. The amount of damage sustained to the clear coat determines to what degree it can be restored.


To fix damaged hair, soak the hair before shampooing, apply leave-in conditioner, coat the hair with argan oil, comb it gently and style it without heat. This daily process takes about two hours, and requires microfiber towels, a comb, shampoo and conditioner, a leave-in treatment and argan oil.


Repairing minor scratches, abrasions or other imperfections in a vehicle's clear coat only requires a clear coat repair kit and some sandpaper. Manufacturers such as 3M, PlastiDip and Mirka produce at-home kits for repairing minor clear coat damage.


The clear coat on a car can be restored by using painters masking tape, 800 grit sandpaper, 1,000 grit sandpaper, 1,200 grit sandpaper, an aerosol can of clear coat paint and cotton towels. It is important when restoring a clear coat that the temperature is roughly 75 degrees Fahrenheit with low hum


Depending on the amount of water in the device, remove the SIM card and memory card along with anything else plugged into the device. Dry with a soft, absorbent towel and place the device in a bowl of uncooked white rice.


To fix a water-damaged ceiling, repair the source of water leakage in the roof, dry the ceiling, fill any holes in the ceiling with joint compound or plaster, and sand, prime and paint the ceiling. Paint the entire ceiling with uniform paint for the best results.


To apply automotive clear coat, apply the coat to the car, and overlap each stroke by 50 percent to prevent tiger striping. Continue until the whole car is covered. Do not rush; adhere to the paint manufacturer's guidelines for time restrictions after application. Ensure that paint application occur


Spray on a clear coat base coat by first sanding any rusty, scratched or irregular areas in the old paint, applying sufficient layers of primer to completely cover the old finish, and finally applying at least three coats each of both the base coat and clear coat. After applying the final clear coat