Web Results


What is Fragmentation threshold in Wireless (WLAN)/ How Fragmentation threshold is used in Wireless Fragmentation Threshold is one more parameter which is given in all stations and Access points. Fine tuning Fragmentation Threshold parameter can result in good throughput but not using it properly can results in low throughput.


The lower the threshold, the more stable your Wi-Fi network, since it asks to send packages more frequently. If you don’t have problems with your Wi-Fi, make sure that the RTS Threshold is set to the maximum allowed. To do this, go to your router configuration and try to find the "RTS Threshold value" in the wireless settings. Set it to 2347.


In most WiFi APs I've seen, the default RTS Threshold is set at 2347 (from what I've read in various places, this setting counts as "disabled"), and Fragmentation Threshold is set at 2346. My particular brand of router is set at 2346 and 2346. I have several questions... Where is the value of 2346 derived from?


The threshold range is around 0 – 2347 bytes; if the packet transmitted by the access point is larger than the threshold, the RTS/CTS function will initiate. If the packet size is less than the threshold or below average, the function will not initiate. RTS & Fragmentation threshold for improved performance


The RTS Threshold protocol is a tricky one to explain, but it helps to clear the channel before data is sent. A lower setting may help in busy WiFi environments as it should reduce collisions, but set it too low or incorrectly and your network performance may suffer. It’s a tricky balancing act to get right. Fragmentation Threshold


Improving Wireless Network Performance by Tuning Advanced Wireless Settings on Wireless Device . Hello! Let's test and try to improve wireless network performance by tuning advanced wireless settings on wireless router or access point if you encounter following problems: - Wireless network adaptor fails to detect any wireless network


What is Fragmentation threshold in Wireless (WLAN)/ How Fragmentation threshold is used in Wireless. What is RTS threshold in wireless. Sitemap. Wireless Protocols and Basics of wireless protocols (WLAN 802.11a/b/g/n)‎ > ‎ What is RTS threshold in wireless. RTS is "Request to Send" . It is used with CTS "Clear to send" .


This leaves nothing to do apart from tweaking the advanced wireless settings to marginally improve problems related to weak signal and/or RF interference, so I've been reading everything I can find on these boards and elsewhere about changing Fragmentation Threshold, RTS threshold, and beacon interval.


After playing around with different settings I think I figured it out. I changed the Fragmentation Length (256-2346) and CTS/RTS Threshold (1-2347) both to 2304. I am now getting 13 down wireless and 15 down wired ... Slow wireless speeds


In part two of his Home Wi-Fi performance series, Sandro Villinger provides more tips to speeding up your home network. ... Unless you’re facing problems with an unreliable network, reducing the fragmentation threshold is not recommended. Make sure it is set to the default settings (usually 2346).