Web Results


To remove small areas of mold from carpet, clean the carpet with dish-washing detergent and a carpet steam cleaner and then let the carpet dry out. To remove larger areas of mold, replace the section of carpet.


High indoor humidity, flooding, spilled liquids and extreme temperature fluctuations are common causes of mold under carpeting. Mold typically develops when moisture, dust and mold spores are present.


It is not possible to kill mold in carpet; instead homeowners must fix water problems and then scrub away remaining mold, remove the carpet and install new carpet. The mold cannot be "killed" on the carpet because carpet is absorbent and porous, meaning that a moldy carpet has mold inside of the fib


Stachybotrys chartarum and Stachybotrys chlorohalonata, commonly known as "black mold," are two species of fungi. They are associated with poor indoor air quality, and frequently appear after water damage to building materials.


Remove mold from outdoor carpet by soaking the carpet in vinegar before steam cleaning the carpet or washing it off with a garden hose. Cleaning requires vinegar, a steam cleaner or garden hose and water. Depending on the size of the carpet, removing the mold takes one to two hours.


To remove black mold, wash the affected area with detergent, and disinfect the area to kill the mold spores. It is necessary to eliminate any sources of moisture in the room to remove the mold successfully. The removal process can be completed in a few hours.


Black mold growth occurs when mold spores travel through the air and land in a wet environment, according to the Centers for Disease Control and Prevention. Black mold requires constant moisture and usually flourishes on materials with low nitrogen and high cellulose content, such as fiberboard, gyp


To clean black mold, wash the surface of the material with soap and water, and then disinfect the area with bleach or a commercial mold killer. Some porous materials must be replaced if the mold cannot be removed.


To kill black mold, wash the moldy area with detergent, then coat it with a bleach and water solution. Finally, apply a borate-based solution to the area. Allow the surface to dry completely between each step.


To remove black mold, prepare the area by sealing vents and doorways with plastic sheeting and duct tape, open windows to ventilate the area, and wash all contaminated surfaces with detergent and water. Always wear safety gear such as gloves and safety glasses to prevent health risks posed by black