articles

Lighting a gas wall heater pilot light requires locating the valve, starting up the gas and igniting the gas with a match or lighter. The procedure is the same for a relight, except the furnace must be turned off for abo... More »

www.reference.com Home & Garden Heating & Cooling

Light a pilot light with a match. Fine wire might also be required to clean the pilot opening if the flame fails to remain lit. More »

www.reference.com Home & Garden Home Maintenance

Once the pilot valve has been set to the "pilot" position, lighting a pilot light simply requires using a match or lighter. After the pilot light is producing a steady flame, the valve can be set to the "on" position, wh... More »

www.reference.com Home & Garden Heating & Cooling
similar articles

To relight a gas heater pilot light, turn the valve to the off position for three minutes then switch to the pilot position; hold a lit match to the pilot opening and press the reset button until the flame burns brightly... More »

www.reference.com Home & Garden Heating & Cooling

If a gas wall heater is not operating correctly, some things to check are the thermostat, the breaker box, the pilot light and the gas valve. If the odor of gas is detected, however, one should call a professional to dia... More »

www.reference.com Home & Garden Heating & Cooling

Pilot light systems can be lit with a match or lighter, but it's best to turn the pilot valve to the "off" position to let the gas disperse first. The valve should be moved to "pilot" from the "off" position and then to ... More »

www.reference.com Home & Garden Heating & Cooling

To light a Dyna Glo propane heater, assemble the heater, connect it to a propane supply system, open the propane supply valve, and light the burner or pilot light. To stop the heater, close the valve on the propane suppl... More »

www.reference.com Home & Garden Heating & Cooling