Web Results


To ignite your device’s pilot light, you’ll need to insert a fireplace key into the gas valve knob located to the left or right of the fireplace. Once you insert the key, do not turn it until after preparing your lighter, otherwise you may release a dangerous amount of gas into the room.


Fireplace and Gas Log Lighting Instructions. Ventless Gas Fireplaces, Ventless Fireplaces, Ventless Gas Fireplace Inserts, Ventless Inserts ... by Ventless-Gas-Fireplaces.com ... If piezo ignitor does not light the pilot, refer to your manual for Match Lighting Instructions.


Failing fireplaces can ignite your anger, but don’t lose your cool when your gas fireplace won't start. Fireplace repair experts recommend trying the following troubleshooting techniques to make your gas fireplace go up in flames — in a good way. How to inspect a gas fireplace that won't turn on? Step 1.


This is an instructional video on how to ignite a gas fireplace with a standing pilot. ... How to light a Gas Fireplace pilot light with ... How To Tell The Difference, and Decide Which One You ...


Most gas fireplaces have a standing pilot light, which is a small flame that burns even when you aren't using the fireplace. This makes the fireplace easy to start when it's cold outside, but when it warms up, it's a good idea to shut off the pilot to conserve gas. If you do, you have to restart it at the beginning of the next cold season.


There are two ways that a gas fireplace/insert/stove will light. It will either have an electronic ignition, or a standing pilot. Electronic ignition is when the pilot light on a gas fireplace/insert/stove is only running when the fireplace is on, this means that the unit is likely to have a battery backup as well.


Pilot Light. The installer should do the initial lighting of the pilot light during installation. Once you begin the operation of the gas fireplace, you can run the pilot light in one of two modes.


Procedure for lighting a standing pilot in a gas fireplace, or other gas appliance. Ignitor. Skip navigation ... How to Safely Light Your Pilot on Your Gas Fireplace, Stove and Gas Log Set ...


At Ignite Gas Fireplace we know how difficult it can be to find a gas fireplace repair contractor that you can have faith and trust in. Our hope is that you'll feel confident in our ability to meet all of your expectations and know that our customers are always our number one focus.


If the pilot does not light within 45 seconds, turn the on/off switch back to the off position and wait 15 seconds. Repeat this step as necessary until the pilot ignites. NOTE: If the on switch is left on for more than 60 seconds and the pilot does not light the fireplace will go into "lock out" mode.