Web Results

www.reference.com/world-view/test-amp-draw-refrigerator-compressor-ce975e7c...

Use the amp meter to determine the actual amp-draw value. Adjust it to read the current and set the sensitivity to the highest level, which is typically 40 amps. Clamp on the black wire in the breakout cord, and wait for the refrigerator to cycle on to get a proper reading.

homeguides.sfgate.com/check-amperage-refrigerator-44156.html

The compressor on your refrigerator is designed to draw a certain current load, and comparing the expected to the actual values is important when troubleshooting it. You are more likely to find ...

www.youtube.com/watch?v=eSn74skC4_0

In this video i will share with you my method of checking a refrigerator compressor to see if it is good or bad.

www.youtube.com/watch?v=M4NSnX3jykQ

Video explaining how to test the compressor if you have a refrigerator that is not getting cold. This is a simple test and with a multimeter and some common sense you can do yourself.

www.youtube.com/watch?v=yoF1-4fBD78

Simple video showing you some basics on how to troubleshoot the compressor on your refrigerator. This will work on most refrigerators, they all will pretty much test the same. This test can be ...

www.youtube.com/watch?v=u3QMFXnEWjQ

- STEP 4: Locate compressor relay cap. ( 0:50 ) - STEP 5: Using a flat head screwdriver, remove relay cap. Insert the head of the screwdriver into the slot at the top of the cap.

www.reference.com/world-view/many-amps-refrigerator-draw-63176c1d2927d326

A typical 16-cubic-foot, frost-free refrigerator draws 6 amps of electricity and uses 750 watts. The amps are determined by dividing the watts by 120 volts in the United States. The amps of a specific refrigerator are easily calculated based on the watts listed on the manufacturer's label. An amp is a measure of the flow rate of electricity.

www.youtube.com/watch?v=5LvTdvyIFyg

How to test single phase fridge compressors electrically. This test shows if the windings on the motor are ok. If the compressor passes this test but it can't start probably the starting relay ...