Web Results


Boat floor replacement Ricksos1. Loading... Unsubscribe from Ricksos1? ... How to build a boat floor that won't get hot - Duration: 18:31. Ryan Moody Fishing 103,509 views.


You cannot repair the boat floor while rotten wood remains as it will only continue to rot. Once you are confident that the rotten sections have been removed, you can start to repair the floor as needed. If you have the means and resources to remove a piece of the boat floor and replace it then that is the best thing you can do for the boat.


The need for a new boat floor becomes inevitable when the floor has a soft, spongy feel that is a sure sign of dry rot. However, the need for replacing a boat floor does not mean the end of your boating days. You can replace your floor in a short amount of time and with minimal labor.


How Do You Replace a Boat Floor? To replace a boat floor, remove all items on the floor, take out the old floor, and use it to cut plywood for the replacement flooring. Coat the new floor pieces with epoxy, and attach them in place. Place fiberglass mat on the plywood, seal it, and lay a floor covering. Finally, replace the items on the deck of ...


Fiberglass boat flooring replacement is a common procedure that a lot of boat aficionados perform to restore their boats and keep them in good shape.After years of use, flooring can get damaged, particularly if left exposed to all weather conditions for a long time. Therefore, it will need replacing.


Re: Replacing Boat Floor It's a 1980s era Bayliner. If the floor is rotted, you've got more problems than just the floor. VERY good chance you'll have to replace the stringers as well, and give the transom a VERY close look for any rot, too. They usually rot from the bottom up, starting at the stringers.


It sounds like you mean the cabin sole: the ‘floor’ inside the boat on which you stand. Note that the term ‘a floor’ or ‘floors’ on a boat means something else: the transverse members (timbers or steel beams or GRP struts that run across the boat)...


Then it’s time to replace your pontoon's floor. ... speakers or whatever other electrical things you are going to have on your boat. Label these wires, too, so you can easily connect the correct wires that will be running under the floor of your boat with the correct switches and corresponding wires that you clipped in your console. ...


Remove the decking from the boat. Measure the width of the deck, using a tape measure. Crosscut the plywood sheets with a circular saw, if necessary, for a proper fit. Lay the first sheet of plywood on the deck, starting at the bow. You want the edge of the plywood to fall in the center of a deck beam.