Q:

How do you use a trickle charger?

A:

Quick Answer

A trickle charger is used to constantly charge a car battery at the same rate at which the battery self-dissipates its charge. A trickle charger is used by connecting the positive cable of the charger to the positive end of the battery and connecting the negative cable to an available ground source.

Continue Reading

Full Answer

  1. Find a suitable place for the car

    Prior to setting up the battery for charging, find a suitable place to leave the car during the charging period. The place selected should be properly ventilated and free of rain.

  2. Set the voltage and amperage of the charger

    Each battery dissipates its charge at a fixed rate, depending on the battery's specifications. Find the appropriate voltage and amperage of the battery from the manual for that particular type of battery, and set the values accordingly in the trickle charger by adjusting the switches.

  3. Connect the positive cable to the battery

    Trickle chargers usually have a black and a red cable, and the red cable is typically the positive cable. Attach this positive cable to the positive end of the battery through the clip at the end of the cable.

  4. Connect the negative cable to a ground source

    The negative cable of the charger must be connected to an appropriate ground source. Ideally, the engine block or any bolt attached to the car's chassis is a suitable option for this purpose. Under no condition should the negative cable be attached to the battery because it could lead to an explosion.

  5. Turn on the charger

    After setting the voltage and amperage on the charger and attaching the cables to the appropriate positions, turn on the charger by plugging it into a power source and switching it on.

Learn more about Car Parts & Maintenance
Sources:

Related Questions

  • Q:

    How do you operate a Battery Tender Plus car charger?

    A:

    To operate a Battery Tender Plus car charger, first connect the charger to the battery. The charger is fully automatic and can be connected to AC power and the battery for extensive time periods, though instructions recommend that you check the charger and battery periodically for proper operation. The car charger has two status lights -- red and green -- indicating the mode of the charger and the battery's condition, so you can check the status of your battery easily.

    Full Answer >
  • Q:

    How do you use an Exide car battery charger?

    A:

    To use an Exide car battery charger, remove the battery from the vehicle, attach the charging cables to it, and choose the appropriate voltage and amperes on the charger. Then, provide power supply to the charger, and adjust the charging time to charge the battery for the required period. Finally, disconnect the charger, and replace the battery in the vehicle.

    Full Answer >
  • Q:

    How can you hook up a car battery charger?

    A:

    Car battery chargers connect to car batteries with positive and negative cables and clamps, which are usually red and black and marked with a plus and minus sign. The positive clamps connect to the positive posts on the batteries themselves, and the negative clamps connect to vehicle frames or some other unpainted surface away from the battery.

    Full Answer >
  • Q:

    How do you refurbish a car battery?

    A:

    To refurbish an old car battery, wash the outside, remove the cell covers, refill the cells with distilled water, and charge the battery. The process should take no more than one hour. Working with car batteries can be dangerous, so use caution when performing this task.

    Full Answer >

Explore