Press the code numbers on the door of the Ford Expedition to unlock the door, and then lift the door handle to open the door. If you want to use your own code for the door, you must follow a few more steps.Continue Reading
Press the appropriate numbers that correspond with the factory-set code for the Expedition. If you desire to continue to use the factory code, simply lift the door handle and open the door. If you want to change the code, proceed to the next step.
Push the 1-2 button on the keypad within 5 seconds after entering the factory-set code.
Type in the new 5-digit code that you would like to use to gain access to the vehicle. Make sure that each number is pressed within 5 seconds of the previous number.
Wait as the doors lock and then unlock. Once you hear this happen, this means that the personal entry code has been completed and is properly programmed. The next time that you unlock the Expedition, all you need to do is enter the 5-digit code to gain access to the vehicle.
Features on the 2015 Ford Expedition include an all-new platinum styling, new exterior styling, 22-inch polished aluminum wheels, King Ranch interior and available ambient lighting. Other features include keyless entry with push-button start and a blind spot information system.Full Answer >
A trouble or error code of P1151 on a Ford Expedition indicates an overheated exhaust oxygen sensor. This may occur because of a problem in the sensor or a problem in another system that overheats the sensor.Full Answer >
As of 2016, reported problems with the 2009 Ford F-150 include defective door handle spring retainers, maladjusted brake stop lamp switches and excessive spark plug gaps that cause ignition coil failure. F-150 owners also report spark plugs ejected from the cylinder heads, and leaking engine oil pan gaskets. Ford recalled the trucks in 2009 for dealers to remove, adjust and reinstall brake stop lamp switches. The automaker issued a recall in 2011 to correct the F-150 door handle problem.Full Answer >
Code P0316 on a Ford means the power train control module detected a misfire shortly after startup. This code requires a check for appropriate technical service bulletins, as there are some bulletins that involve reprogramming the power train control module.Full Answer >