Q:

What rpm should my car idle at?

A:

Quick Answer

Idle speeds vary from car to car, but for a passenger car, typical idle speeds are between 500 and 900 rpm. This idle speed also depends on the accessories that are currently running as a car's idle control system will automatically raise the idle in order to provide power for auxiliaries such as air conditioning and power steering.

Continue Reading
What rpm should my car idle at?
Credit: PeterAustin E+ Getty Images

Full Answer

An engine idle speed is set by the manufacturing in order to ensure the best performance and life of the engine. If idle speed is too high, then the engine's economy will suffer, as the fuel consumption will be increased. This also means that there will be higher emissions and environmental side effects, as well as an increase in engine wear. Consequently, if the idle speed is set too low, then engine damage can occur from auxiliaries such as the water pump and oil pump not operating effectively enough to maintain proper cooling and oil lubrication, respectively. In addition, the engine itself may not be producing enough power to overcome its own frictional losses, and thus will rough roughly or stall. According to About, a good idle is typically an indicator of engine health, and if there is anything wrong under the hood, then idle quality is likely to suffer first.

Learn more about Car Parts & Maintenance

Related Questions

  • Q:

    How much transmission fluid does a car hold?

    A:

    The average amount of transmission fluid a passenger car can hold is approximately 12 quarts, but it can be as much as 36 quarts dependent on the vehicle model and type. The owner's manual for a vehicle lists the amount of transmission fluid that the vehicle's engine can hold.

    Full Answer >
    Filed Under:
  • Q:

    What are the standard drive belt sizes?

    A:

    Drive belt lengths vary greatly according to the power needed to be transmitted and the speeds of the driving and driven units. The width of drive belts are set according to the industrial standard part number by which they are coded. The most common industrial standard part numbers are A-section, B-section, C-section, D-section, E-section, AX-section and BX-section. A-section belts are 1/2-inch wide and D-section belts are 1 1/4-inches wide. All the other belt types have widths between these two extremes.

    Full Answer >
  • Q:

    What is No. 2 diesel fuel?

    A:

    Number 2 diesel fuel is a special grade of diesel used in high-speed engines that bear constant loads under fairly constant speeds. One common application of Number 2 diesel is in railroad locomotives.

    Full Answer >
  • Q:

    What causes a shimmy in a steering wheel?

    A:

    Steering wheel shimmies that occur at speeds of 55 to 60 miles per hour are often due to tire or tire balance problems. Vibrations that only occur during braking are usually due to bad brakes. The steering wheels of some vehicles shimmy due to a problem with the steering linkage.

    Full Answer >

Explore