Q:

How do you replace the valve cover gasket on a 1991 Toyota MR2?

A:

Quick Answer

Since replacing a valve cover gasket is practically universal to all vehicles, you can do it on a Toyota MR2 as you would for any other vehicle. A properly installed gasket allows for the correct oil circulation and compression. Make sure you have the correct gasket and proper sealer before you begin the process, which involves removing the cover, replacing the old gasket and letting the new one set.

Know More

Full Answer

  1. Remove valve cover

    First, locate the valve cover, and then undo all the screws. The old gasket should still be in place when you pull the cover off. Use a razor or any sharp edge to scrape the area clean of any debris from the old gasket.

  2. Prep the new gasket

    Apply the sealant to one side of the gasket, and place it face down on the clean surface. Make sure to line up all the holes for the screws correctly. Apply the sealant to the side facing up, and place the valve cover back on top of the new gasket.

  3. Allow the new gasket to set

    Put the screws back into their rightful places, and let the sealant set for at least eight hours. This part is critical because the sealant prevents oil from leaking. After allowing the sealant to dry, start the engine, and watch your oil gauges carefully. Make sure the oil doesn't get too hot or too low.

Learn more about Engine
Sources:

Related Questions

  • Q:

    What does a crankshaft sensor do?

    A:

    Typically located in the timing cover or directly inserted into the lateral portion of the main block of an engine, the crankshaft sensor establishes the ignition timing for a vehicle. It also determines engine speed.

    Full Answer >
    Filed Under:
  • Q:

    How can I stop an engine oil leak at the valve cover gasket?

    A:

    To stop an engine oil leak at the valve cover gasket, expose the vehicle engine, remove the valve cover and gasket, insert the new gasket, and replace the valve cover. You need the vehicle manual, a wrench, a screwdriver, a mallet, a newspaper and a new gasket.

    Full Answer >
    Filed Under:
  • Q:

    What is the typical cost to repair an oil gasket leak?

    A:

    The average cost to repair an oil gasket leak is $396 to $511 if the oil pan requires resealing, and $249 to $348 if the valve cover gaskets require replacement. RepairPal.com bases these prices on the national average for all vehicle makes and models.

    Full Answer >
  • Q:

    Why is there oil in my spark plug wells?

    A:

    Oil appears in the spark plug well when there is a leaking valve cover gasket or when an O-ring weakens or loosens. Each spark plug has an O-ring that prevents oil leaks. When the O-ring breaks, oil begins to pool in the spark plug well. The valve cover gasket also causes oil leaks when it is worn out or not installed correctly. Valve cover gaskets are typically mounted on top of an engine to prevent oil from leaking onto other mechanical parts, such as the spark plugs.

    Full Answer >

Explore