To program a Viper door, you need to open a door first, and turn the ignition. Press and hold the Valet button. Finally, program the remote.Continue Reading
You need to open only one door of your vehicle to begin programming your Viper remote. Whichever door you choose, ensure that the dome light comes on after the door has been opened.
Place the key into the vehicle's ignition, and turn it on to the Run position labeled on the ignition.
On the Viper remote, press the Valet button once to begin programming the channel of your choosing. Then, press the Valet button one more time. If this was done successfully, you should hear a mild honk, or see your LED lights flash.
After you have been signaled by your vehicle that it has programmed the channel, press and hold the Valet button.
Continue holding the Valet button, and press the button on the transmitter that you wish to have programmed on the remote. If successful, you will hear another honk, or your LED lights will glow. Repeat this step if you wish to perform additional programming. You can now release the Valet button you were pressing. Your Viper remote is now programmed with your vehicle.
Many modern car keys and remote opening systems require owners to contact the vehicle's manufacturer to obtain a new key or remote. However, it is possible to obtain or install third-party keys, remotes or ignition systems for some vehicles.Full Answer >
Installing a Viper remote start system involves running power and control wires to several circuits throughout the vehicle and installing several components including an LED indicator, valet switch, antenna and a hood switch.Full Answer >
A Viper car alarm can be installed using the instructions found in the Product Guides and Manuals page in the Support section on Viper.com. Viper car alarm installations usually require an intermediate to advanced level of auto knowledge, including knowledge of interior assembly and disassembling.Full Answer >
To reset a Viper car alarm, use the key fob by pointing it at the vehicle. Wait for the alarm to sound for six seconds, and then press the lock button on the key.Full Answer >