To program a Dodge key fob, press and release the "Lock" button five times within about 10 seconds. Insert the key, and turn it to the run position. Press and hold the "Unlock" button. While holding "Unlock", press and hold the "Panic" button for one second. Release them simultaneously. Wait for the car to cycle the locks then press "Lock" and "Unlock." Release them and press and release "Unlock."Continue Reading
Dealerships charge $50 or more to program key fobs. Before going that route, most consumers will try to do it themselves.
Programming a Dodge key fob can differ between models. For example, to program a 2006 Ram 1500, the first valid key is put into the ignition and turned to the "On" position for at least three seconds and no longer than 15 seconds. The key is then turned back to the "Off" position and removed from the ignition.
A second valid key is then put into the ignition and switched to "On" for 15 seconds. After 10 seconds, the security light will flash, and the key is turned to "Off" and removed.
Next, a blank Sentry key is put into the ignition and switched to "On" within 60 seconds of removing the second key. After ten seconds the security light stops flashing, and the third key is turned to "Off" and removed.
This step has programmed the new Sentry key. The Keyless Entry Transmitter has also been programmed at this time. The process can be repeated to add up to six additional keys.Learn more about Car Makes & Models
To program a car's keyless remote entry system, close all the doors of the vehicle, switch on the dashboard lights using the key, and press Lock on the car's remote for a brief period. Then, switch off the dashboard lights, and repeat the process until the locks make a clunking noise. Again, press Lock, switch off the ignition, take out the car's key, and test the remote for correct programming.Full Answer >
Program the key fob for most Ford vehicles by entering the programming mode and pressing any button on the fob. It is necessary to reprogram all fobs for a vehicle at the same time to ensure all key fobs open the vehicle.Full Answer >
To use the remote start button, which is located on the key fob transmitter, press the lock button to lock all the doors. When you press the remote start button twice, the exterior lamps flash twice, and the car starts.Full Answer >
To program your car key fob, switch the ignition on using the key, and quickly press the lock button on the fob. Release the button and switch off the ignition. Perform these steps four times in quick succession to put the fob into the programming mode. Then, press lock, release, and switch off the ignition.Full Answer >