The ABS light in a Ford Explorer comes on and stays on when there is a problem with the brake system or in cases where spark plugs are wearing thin. This light indicates there is an issue with stopping power that generates issues when trying to stop rapidly or in bad weather. An ABS light sometimes comes on just before engine failure but coincides with all lights turning on.Continue Reading
The antilock brake system or ABS is in charge of ensuring that the brake system does not lock up when trying to stop rapidly or in an emergency situation. In the old days, drivers needed to flutter the brakes or pump them to avoid locking. Modern systems do this automatically when the brake is depressed quickly and completely.
The ABS light in a Ford Explorer comes on and stays on in instances where this systems is not working. This occurs when the system shorts out or stops working altogether. This is an electrical interface and therefore relies on spark plugs and other solutions that generate power and maintain electronic systems. The ABS light indicates the system is offline, the sparks are dying or that the signal responsible for transmitting information between the system and the dash lights is wet.Learn more about Brakes
An ABS module, or ABS control module, refers to a car's anti-lock brake system, which controls the ABS system. The controls are directed in response to data that is gathered from the sensors placed around the car. The ABS module is usually found near the engine.Full Answer >
The first step to troubleshooting an anti-lock brake system is checking the fuse that manages the brakes. If the fuse is functional, check the harness of the ABS controller for signs of corrosion. Then check the wheel sensors. If those are in order, you might need a new ABS controller.Full Answer >
Some reasons that the ABS light stays on in a vehicle are the emergency brake not going down far enough, a loss of hydraulic pressure, malfunctioning hydraulic circuits, and a dirty ABS wheel sensor. The ABS system usually generates a diagnostic code if the light has been triggered, which can be read by a service technician who can then properly diagnose the cause of the problem.Full Answer >
Brake bleeding on a vehicle is a mechanical process that removes air from the brake fluid in the hydraulic system when repairing brakes or performing brake maintenance; the term does not typically describe a problem that needs to be fixed. Bleeding a brake system is typically required when the brake fluid is low, resulting in squishy or soft braking typically associated with a leak that has drained brake fluid from the system.Full Answer >