A car alarm without a remote can be disarmed by opening the door with the conventional key and then locating the valet switch. Upon entering, the alarm sounds. Locate the switch immediately, insert the key into the ignition cylinder, turn it to the on position and gently hit the valet switch once.Continue Reading
This should reset the alarm, stop its blaring sound and enable the car to start. If tapping the switch once does not work, turn off the ignition and try the process again several times. The alarm system may have been programmed to require up to five taps on the valet switch.
Most people find themselves in this situation when they have lost or damaged the remote to their cars. In this case, it is always important to know where the valet switch of the alarm system is located.
Sometimes the alarm may not be disarmed even when the remote is pressed. This might be due to low batteries. When the remote has to be pressed several times to open or lock doors, it is a sign that the batteries need to be replaced. Read the manual to determine what needs to be done. Different alarms are programmed differently, so what works on one car might be ineffective on another.Learn more about Car Parts & Maintenance
A passive car alarm turns on automatically when the key is removed from the ignition and the car doors are closed. This type of alarm is considered "passive" because the driver does nothing to turn it on.Full Answer >
To program a car's keyless remote entry system, close all the doors of the vehicle, switch on the dashboard lights using the key, and press Lock on the car's remote for a brief period. Then, switch off the dashboard lights, and repeat the process until the locks make a clunking noise. Again, press Lock, switch off the ignition, take out the car's key, and test the remote for correct programming.Full Answer >
To repair a car door lock, put a new battery into the auto key lock, and make sure that other locks work. If they don't, replace the fuse. Press the key on the auto lock, and lift the door up and down. The door mechanism is frozen if you hear that the lock tries to move. In addition, slowly open and close the door while pressing the button. If the lock works, repair a broken wire associated with the lock.Full Answer >
Installing a Viper remote start system involves running power and control wires to several circuits throughout the vehicle and installing several components including an LED indicator, valet switch, antenna and a hood switch.Full Answer >