Thermostats in four and six-cylinder Dodge Stratuses are changed by removing the radiator hose and replacing the old thermostat with a new one. It should then be set in place with the protruding pin sticking outward. Lastly, the thermostat intake housing gasket and radiator hose should be bolted back in place, and radiator fluid should be replaced as needed.Continue Reading
To change a thermostat in a four-cylinder Dodge Stratus, you need a screwdriver and wrench. Start by removing the radiator hose from the thermostat intake hose. To do this, loosen the band clamp. There are two bolts that secure the housing to the intake manifold. Remove the bolts to lift the housing off the intake. Next, lift the old thermostat out of the intake manifold, and replace it with the new thermostat. The side of the thermostat with the pin protruding sticks out of the intake manifold. Replace the thermostat intake housing gasket and bolt into place. Finish by reconnecting the radiator hose.
For a six-cylinder engine, drain the radiator fluid by loosening the petcock on the lower right hand side, then close it back up. Remove the radiator hose from the lower thermostat outlet by loosening the band clamp. Pull the thermostat outlet off the block, discarding the two bolts that secured it along with the O-ring. Replace the old thermostat with the new one, and just like the four-cylinder engine, the end with the pin should protrude from the engine block. Secure into place, and reattach the radiator hose before refilling it with fluid. Always make sure the vehicle is in park and the parking brake is applied.Learn more about Car Makes & Models
To change a thermostat, detach the radiator hose from the thermostat housing, and then remove the housing to replace the old thermostat. You need a bucket, pair of pliers, set of mechanic's tools, clean rag, gasket scraper and new gasket.Full Answer >
Replacing the thermostat on a Ford Explorer requires draining the coolant from the cooling system, disconnecting the upper radiator hose and removing the housing. Thermostat replacement is a low-skill maintenance procedure that can prevent the Ford Explorer from overheating, which can cause damage to the engine.Full Answer >
The 1996 through 2006 Dodge Stratus models each hold about 16 gallons of gas. As of 2014, drivers of a Dodge Stratus spend an average of $1,000 more on fuel-related costs than the average driver of a new car during a five-year period.Full Answer >
Replace the filter on a 3-ton air handler by turning the system to Off at the thermostat, locating the filter compartment, removing the old filter and replacing it with a new one. Depending on the amount of use and air quality, filters normally require replacement every three to six months.Full Answer >