The steps to programming a remote from Pioneer vary between models. The basic operation includes holding down the remote's main setup button before entering the specific manufacturer code of the TV or device in question.Continue Reading
Turn on the TV. The first programming scenario begins by entering Set Mode by pressing down both the CATV and the TV button for three seconds until the remote's LED light flashes repeatedly. Repeat this step if the light stops flashing. Once the light begins to flash, press down on only the CATV button until the light stays on. Press "0, 0, 2, 5" in that order until the LED light blinks twice and turns off. Enter Set Mode again and press CATV. Then, enter the manufacturer codes until the TV turns off. For unknown codes, turn the TV on and enter Set Mode. Press TV before pressing one of the remote's up arrow buttons slowly and repeatedly until the TV turns off.
For the following programming instructions, Device button refers to the TV, VCR and AUD buttons, while device refers to TVs, VCRs, DVD players and audio equipment. DVD players are programmed to the VCR button, while audio equipment is programmed to the AUD button.
For universal models that are designed to work with complete home theater systems, begin by turning on the device. Press and hold the Setup button until the LED light comes on, then off. Release the Setup button and proceed when the LED light blinks once. Press the Device button before entering the manufacturer codes until the LED light blinks twice. Press the Device button to turn the device off to ensure the operation worked correctly. For unknown codes, repeat the operation, but instead of entering the manufacturer codes, press Select slowly and repeatedly until the device turns off. Then, press the Device button to save the code.Learn more about Television & Video
The Geek Squad service from Best Buy allows users to hire someone to program remote controls for about $100, as of 2015. In addition, remote control programming is typically included when an electronics specialist is hired to set up a home theater system.Full Answer >
Manuals for remote controls are normally available on the websites of their manufacturers, such as the Dish Network. Users can also find remote control manuals on websites that aggregate documentation for remote controls from different brands and manufacturers. Such websites include RemoteCentral.com, Retrevo and ManualsOnline.Full Answer >
Finding instructions for remote controls online is possible by navigating to support sections of websites, such as TimeWarnerCable.com or MyDish.com, and accessing programming instructions and manuals for the desired remote control model. These instructions are manuals are also available on third-party websites that aggregate manuals from different brands. Such websites include ManualsOnline.com and Retrevo.com.Full Answer >
Use the manual search code or the direct entry code to setup your RCA remote control. Both methods use a pre-programmed code that identifies the device.Full Answer >