Q:

How can a 24-volt DC battery charger be made?

A:

Quick Answer

According to the Do It Yourself website, a DC battery charger can be made by combining a power bulb base, a silicon diode, insulated wire, a connector and a AC to DC converter. These parts should be assembled together correctly for the charger to be able to send AC power to a DC source.

Continue Reading

Full Answer

A power supply, such as a wall socket, is normally run on AC charge. This charge is different from DC charge in that it is not portable and remains in the position that it is in throughout its lifetime. AC and DC are similar and can be exchanged with the use of a converter. For the converter to work properly, the voltage that is contained within the AC source should be compatible with the voltage that is being directed toward the DC source. The purpose of the DC charge is that it is of lower density and does not have as high of voltage as AC, making it safer for portable use.

The wire that is being used for the conversion of AC to DC power sources should be copper wire. This ensures that the power from the silicon diode and the converter is correctly distributed throughout the entire charger. This power goes through the light bulb base as well and is the basis for charging the DC voltage that is directly connected to the battery.

Learn more about Technology
Sources:

Related Questions

  • Q:

    How do you install a backup camera?

    A:

    Mount the camera, run the wire into the trunk for the transmitter, connect the transmitter to the cars power supply and replace the rearview mirror are the steps needed to install a backup camera on a vehicle. Installation procedures may vary depending on the vehicle's make, model and year.

    Full Answer >
    Filed Under:
  • Q:

    How do you wire a 12-volt toggle switch?

    A:

    Wiring a 12-volt toggle switch involves cutting the wire that powers the accessory and attaching either end to the terminals of the switch. When the toggle switch has three terminals, make sure one of the wires attaches to the center terminal and the second to either of the two remaining terminals.

    Full Answer >
    Filed Under:
  • Q:

    How do you wire a car stereo?

    A:

    Wire a new car stereo using a wire harness, along with speaker wire if necessary. Disconnect the ground wire from the car battery before you start work. Wire the speakers first, and then wire the head unit. Connect the amplifier to the power supply and then to the subwoofer. Return the stereo head unit to the dash, reconnect the ground wire, and test the stereo before replacing the dash.

    Full Answer >
    Filed Under:
  • Q:

    Should you have a professional install a GPS unit in your car?

    A:

    A typical driver should have a professional install an aftermarket GPS navigation unit in a car, as the process requires making wire connections and finding the correct location for the GPS antenna, but drivers who have the time and ability can perform the installation themselves. Common benefits of professional installations include a warranty and free reinstallation of the factory equipment, if necessary.

    Full Answer >
    Filed Under:

Explore