To load Nosler bullets, set up a clean, clear reloading bench, work out a reloading procedure, put on safety glasses and place the bullet case in a press. Add the primer, powder and bullet to the bullet case.
Run through the following steps to load Nosler bullets.
- Set up a working area
- Draft a reloading procedure
- Put on safety gear
- Set up the bullet press
- Add the bullet casing
- Add the primer, powder and bullet cap
Make sure the area is clear of dirt and dust and is not exposed to any heat or smoke. Do not attempt to smoke while loading the bullets.
Before loading bullets, define a procedure outlining each step. Consult the product loading recommendations to find the right specifications. Be sure to follow these exactly. Nosler publishes bullet load data for each bullet model on its official website, Nosler.com.
Wear safety glasses to protect the eyes while loading.
Set up the bullet press on the bench.
Insert the bullet case into the press.
Add the bullet primer, powder and bullet cap to the case according to the press manufacturer's instructions. Different bullet presses operate in different ways, so it is important to consult the product manual to ensure that the bullet is safely loaded. In addition, consult the product guidelines for the Nosler bullet model, as too much powder can cause severe accidents.