To hang a panel of stained glass, drill stud holes in the panel frame, insert wood screws and washers, fasten the panel to the wall, and level it. The required supplies are: a stud finder, a drill, wood screws, washers, a screwdriver and shims. You also need assistants.Continue Reading
Use a stud finder to locate two studs. With the help of an assistant, hold the stained glass panel against the wall, and mark the stud locations on it. Lay the panel on a flat surface, and drill at least two holes for each stud. Place one hole at the top of the frame and one at the bottom. Position the holes at least 1/2 inch away from the glass.
Place a washer over each hole, insert 3-inch wood screws, and tighten them with a screwdriver.
Have two assistants hold the panel against the wall. Use the screwdriver to drive the screws into the wall until the frame lies flat against it.
Examine the position of the panel. If it is not flush against the wall, remove it, screw wooden shims into the back of the frame, and remount it.