The temperature of hot tap water should be around 50 degrees Celsius. For cold tap water, the temperature is roughly 7 degrees Celsius. These temperatures are estimates and vary according to season and geographical location.
A:The standard size of a bathtub is 60 inches long, 32 inches wide and 18 inches tall. Standard-sized tubs are designed to fit into an alcove, surrounded by three walls. Alcove tubs are available in a wide variety of materials.
A:The key differences for a homeowner choosing between well water and city water lie in who is responsible for the transport of the water, purity of the water and maintenance of pipes, pumps and septic systems. In addition, some people find a difference in taste between well water and city water.
A:Overflowing toilets are most often caused by blockages or defects in the plumbing or the tank float mechanism that regulates water flow. Water builds up inside the toilet, but because there is a blockage where the water usually escapes, the water level increases to the point of overflowing.
A:Residential water pressure should not exceed 80 pounds per square inch, or psi, and outdoor irrigation systems typically have a water pressure of 30 to 50 psi. Sometimes water is supplied to houses at 100 or even 150 psi.
A:After you flush a toilet, the water goes down the sewer pipes to the sewage treatment plant. In places where the home is far away from the sewer system, the waste water goes into large septic tanks. These tanks are cleaned and emptied regularly to keep the home safe.
A:Plumbing experts recommend checking the heater tank's pressure release valve and flushing the tank every six months as part of routine hot water heater maintenance. The tank's anode rod should be checked annually and replaced if it is less than 1/2-inch thick or if it is coated with calcium.
A:Do It Yourself mentions epoxy resin as a method of fixing narrow-yet-deep holes. Sand the area around the hole with 100-grit sandpaper, and push the resin into the hole with a thin applicator. Smooth away any resin around the surface, and allow to dry as prescribed by the instructions. Then, using 200-grit sandpaper, even out the resin with the rest of the surface.
A:The typical bathtub holds 80 to 110 gallons of water depending on its depth and measures 60 inches long and 30 inches wide on the outside, according to SF Gate Home Guides. The capacity of any bathtub is determined by taking measurements and multiplying the inside length, width and depth.
A:EPA restrictions enacted in 1994 limit standard showerheads to a flow rate to 2.5 gallons per minute (gpm). This is not only to save water, but to save energy usage by the water heater. Previously, shower heads had a standard flow rate of 5.5 gpm.
A:The standard shower stall size is 3 feet by 3 feet. Most showers are larger than this to make them more appealing to home buyers, but regulations require the minimum be the 3 feet by 3 feet size so that people in wheelchairs can access them.
A:Rust or debris caught between the flapper valve and the bottom of the tank is the most frequent cause of a toilet tank that does not fill. A faulty valve or seal is also common. This problem is usually accompanied by the continuous and noisy flow of water from the tank to the bowl.
A:One of the most common causes of humming pipes after flushing a toilet is debris trapped in an inlet valve. Water carries small stones, calcium deposits and solder to the valve area which traps them, resulting in the annoying noise.
A:Hard water is beneficial because it can provide much needed calcium and magnesium to humans, according to the Utah State University Extension Office. It has also been shown to have a correlation to a reduced risk of cardiovascular disease. Hard water is less likely to cause expensive corrosion of pipes, and it tends to taste better than soft water.
A:Water pipes that make a lot of noise when people run water can be caused by high water pressure, loose mounting straps or even a water hammer. Troubleshooting a water system is an important part of home maintenance because a leak is one of the most expensive scenarios that happens within a home.
A:The only thing that can dissolve hair in drains are strong chemicals such as bleach, sulfuric acid or hydrogen sulfide. There are many commercial plumbing liquids that are able to dissolve the hair in the drain.
A:Cast-iron bathtubs range in weight from approximately 225 pounds for a 48-inch classic clawfoot tub to 500 pounds or more for a 72-inch pedestal tub. The classic model is a smaller tub with four short legs, and the pedestal is a large tub with a built-in base.
A:Charmin, Angel Soft, Coleman and Scott Rapid Dissolving Toilet Paper are safe to use with a septic system. Camco, Green Forest and Seventh Generation are other brands of toilet paper safe to use in a septic system.
A:Toilets make odd noises, such as gurgles and burps, due to the movement of air through water. Most often, the air movement responsible for such noises is due to a clogged or improperly working vent stack. These clogs cause a vacuum to form as water drains. Once the force of gravity empties the water, the vacuum pulls air through the trap.
A:The first step to fix a blocked dishwasher is to make sure it finished its last cycle. Dishwashers don't drain completely until the cycle is complete, according to DoItYourself. The appliance tends to retain some water if something, such as a power failure, interrupts the cycle.