Lighting

A:

To wire a security light, turn the current off, assemble the light, and make the proper wire connections. Always use the utmost level of caution when dealing with electricity, and do not hesitate to contact a professional electrician for help.

See Full Answer
Filed Under:
  • How do you install a chandelier?

    Q: How do you install a chandelier?

    A: To install a chandelier, insert a fan brace into the ceiling, attach the chandelier to it and connect the chandelier to the nearest wiring box. The required supplies are a chandelier, a fan brace, a ladder, insulated gloves, a flat screwdriver, twist-on wire connecting caps, a small pry bar and a wrench. This procedure usually takes about 90 minutes.
    See Full Answer
    Filed Under:
  • Why do your light bulbs keep blowing?

    Q: Why do your light bulbs keep blowing?

    A: When light bulbs blow out repeatedly on a light fixture, the cause is either too much electricity or faulty wiring. There are solutions to each problem.
    See Full Answer
    Filed Under:
  • How can you remove a stuck light bulb?

    Q: How can you remove a stuck light bulb?

    A: Remove a stuck light bulb using a piece of duct tape, a bar of soap or a potato. The likelihood of the bulb breaking is high so gloves and eye protection should be worn while trying to loosen a stuck bulb.
    See Full Answer
    Filed Under:
  • Can LED lights be dimmed?

    Q: Can LED lights be dimmed?

    A: According to Lutron Electronics, not all LED lights can be dimmed. The packaging must be labeled as "dimmable" and an LED-specific dimmer switch must be used.
    See Full Answer
    Filed Under:
  • How bright is an LED?

    Q: How bright is an LED?

    A: LEDs (light emitting diodes) are brighter than incandescent or halogen bulbs of the same wattage, but LED bulbs are not available in high wattages. Some of the brightest LED flood lamps use 11-12 watts and emit light comparable to a 50-watt incandescent bulb.
    See Full Answer
    Filed Under:
  • How do you wire a security light?

    Q: How do you wire a security light?

    A: To wire a security light, turn the current off, assemble the light, and make the proper wire connections. Always use the utmost level of caution when dealing with electricity, and do not hesitate to contact a professional electrician for help.
    See Full Answer
    Filed Under:
  • What are some facts about incandescent light bulbs?

    Q: What are some facts about incandescent light bulbs?

    A: Although it is commonly believed that Thomas Alva Edison invented the incandescent light bulb, he actually just improved on light bulbs detailed in a 1875 patent he bought from two other inventors, Henry Woodward and Matthew Evans.
    See Full Answer
    Filed Under:
  • What is the importance of light in our life?

    Q: What is the importance of light in our life?

    A: People need exposure to light because sunlight provides ultraviolet B (UBV) rays that help the body produce vitamin D. Vitamin D helps balance the calcium that the body needs in order to maintain healthy bones and teeth. The amount of sun exposure a person needs depends on the climate.
    See Full Answer
    Filed Under:
  • How low should pendant lights hang?

    Q: How low should pendant lights hang?

    A: For a standard 8-foot ceiling, a pendant light typically hangs 12-20 inches below, which is 84 to 76 inches above the floor. For every additional foot of ceiling height, the pendant-light drop length increases by 3 inches, according to Better Homes and Gardens.
    See Full Answer
    Filed Under:
  • At what height do you put a chandelier over a bed?

    Q: At what height do you put a chandelier over a bed?

    A: When hanging a chandelier over a bed, the bottom of the chandelier should be approximately 7 feet from the floor, according to SFGate. This height can be achieved by shortening the chain on the chandelier.
    See Full Answer
    Filed Under:
  • Q: What is the difference between LED and incandescent?

    A: Light-emitting diode (LED) and incandescent light bulbs produce light using different technologies. A traditional incandescent bulb produces light by passing electricity through a tungsten filament surrounded by inert gases to heat the filament to approximately 4,000 degrees Fahrenheit. An LED consists of two adjoined pieces of semiconductor material. Energizing an LED causes movement of electrons across the diode, which emits photons or light.
    See Full Answer
    Filed Under:
  • Q: What are some different types of flagpole lights?

    A: In-ground, above-ground, down lighting and solar lights are some types of flagpole lights. Small spotlights, floodlights and LED lights are also often used as flagpole lights.
    See Full Answer
    Filed Under:
  • Q: What some solutions for common dusk-to-dawn lighting problems?

    A: Light-sensitive switches, motion sensors, energy-efficient bulbs and glare caps are some solutions to common dusk-to-dawn lighting problems. Power usage and intrusion into neighboring homes are the main issues with residential dusk-to-dawn security lights.
    See Full Answer
    Filed Under:
  • Q: What type of light bulb is best for a reading lamp?

    A: A light bulb with a brightness of 450 to 800 lumens and a color temperature of 5000 to 6500 Kelvin is a good choice for a reading lamp. This equates to a 10- or 15-watt CFL bulb, an 8- or 12-watt LED bulb or a 40- or 60-watt standard bulb.
    See Full Answer
    Filed Under:
  • Q: How do you find replacement parts for a crystal pendant chandelier?

    A: Find replacement parts for a crystal pendant chandelier by accessing the websites of such retailers as Chandelier Parts or Culbertson Lighting. Big box stores such as Lowe's sell items such as pendant light stem kits, and Amazon.com also cells chandelier crystals.
    See Full Answer
    Filed Under:
  • Q: How do you choose a bathroom light cover?

    A: Choose an opaque bathroom light cover to create softer illumination, or select a clear cover to optimize the light provided by a fixture or sconce. When properly lit, bathrooms should be unshadowed without being bright to the point of causing discomfort. Selecting a fixture that allows for an attractive lighting level depends on the lighting and layout of an individual bathroom.
    See Full Answer
    Filed Under:
  • Q: How do you use vintage lamp parts?

    A: Use vintage lamp parts in new and interesting ways like turning the shades into planters and bird feeders. You can also use the vintage parts to craft an entirely new and unique lamp.
    See Full Answer
    Filed Under:
  • Q: What is an E26 light bulb?

    A: An E26 light bulb refers to any bulb with a medium-sized base. In the United States, medium indicates that the base of the bulb is 1 inch in diameter. Other terms used to reference a medium base include standard and Edison.
    See Full Answer
    Filed Under:
  • Q: What are some common designs for Indian table lamps?

    A: White marble crystal fretwork, art glass in geometric patterns, elephant accent bases, hand-painted brass lamps and pottery lamps are some common designs for Indian table lamps. Also popular are urn designs, antique resin and fabric, and brushed wood designs with figurines.
    See Full Answer
    Filed Under:
  • Q: What are some retailers that carry Malibu low-voltage lighting?

    A: As of 2015, Malibu lights are no longer available through retailers because the company became bankrupt, but consumers can still find Malibu low-voltage lights on eBay.com and Amazon.com. Previous to bankruptcy, Malibu lights were available from Home Depot.
    See Full Answer
    Filed Under:
  • Q: Where is the Duquesne lighting company?

    A: The Duquesne Lighting Company is located in Pittsburgh, Pennsylvania. As of 2015, the mailing address for general comments and any legal questions is 411 Seventh Avenue, Pittsburgh, PA, 15219.
    See Full Answer
    Filed Under:

Explore Decor