The first thing to do when plastering a wall or ceiling is to remove the furniture and lay down large plastic sheets to protect the floor. Once the room has been prepared, begin by mixing the plaster in a large clean bucket.
A:According to Home Guides, there are several ways to reduce the noise in a room. Home Guides recommends covering windows with heavier drapes to help absorb noise. Adding padding underneath carpeting is also another noise-reducing solution.
A:Vinyl flooring is an affordable option for remodeling a kitchen, bathroom or laundry room, and with some careful planning, can be installed in under a day with beautiful results. The process is made simple by taking accurate measurements, removing the old flooring and filling any cracks or holes, then removing base molding and installing your new vinyl material. After trimming to fit, apply adhesive and let dry under heavy pressure to ensure no air is trapped between the subfloor and the vinyl.
A:Grout must set for 15 to 30 minutes before it is wiped for the first time and another 3 hours before it is wiped a second time, according to BobVila.com. In both stages, the grout should be wiped with a wet sponge to remove excess grout on the tile.
A:To repair cracked glass, mesh the broken pieces together using an epoxy glass glue. Apply a thin layer of glue to the cracked edges, and let it dry completely. Then, press the cracked pieces together for about twenty minutes. Pressure must not be applied on the repaired glass for at least 20 hours.
A:Depending on the weight of the shingles being used, a bundle of shingles covers between 20 and 33.33 square feet. The most commonly used bundle covers 33.33 square feet, according to Fine Homebuilding.
A:The process for repairing drywall often depends on the size of the hole or crack. For smaller holes that are caused by nails or screws popping back out of the drywall, simply push the nail or screw back into the drywall and apply drywall compound to the divot to fill it.
A:According to This Old House, the most expensive wood is Macassar ebony. Also known as stripped ebony, this wood has a fine texture and small pores. Macassar ebony is reddish-brown with darker brown highlights.
A:A room 10 feet long and 10 feet wide needs 100 square feet of carpeting to cover the floor. It is common to add an extra 20 percent in case of unforeseen problems, bringing the total to 120 square feet.
A:Bitumen is primarily used to pave roads. It is a brown or black mixture of hydrocarbons, which is derived from petroleum. The consistency of bitumen varies from viscous to solid, and in its solid form, it is commonly known as asphalt.
A:To calculate how much gravel is needed, measure the width and breadth of the area in feet, and determine the depth desired. Multiply the length times the width times the depth for the number of cubic feet, then divide that number by 27 to determine the needed cubic yards.
A:As of 2014, the minimum cost of building a mansion is around $1 million. This cost can vary greatly depending on the cost of the lot on which the home is built, the total square footage of the home, the design of the home and the types of materials used.
A:The most common materials used to make bathtubs are porcelain, acrylic, fiberglass, enameled cast iron and cast polymer, according to About.com. Each material creates a different look, weight and feel for the tub.
A:Installing drywall over a brick fireplace helps to cover unsightly brick and give the home a modern feel. The entire process takes several days. In addition to drywall, you need masonry nails, joint compound, drywall tape and finishing tools.
A:The weight of a pallet of bricks varies based on the size of the pallet, the type of bricks used and the number of bricks used. For instance, a pallet of red clay bricks stacked 4-feet high weighs significantly more than a pallet with a single layer of Lego bricks.
A:Marble is used for kitchen counters and kitchen counter inserts. It's also used for backsplashes, table tops, bathroom vanity tops, flooring, stairsteps and wall tiles, and it is sometimes used for statuary and in building construction. Marble is also used in cosmetics, papermaking and in the pharmaceutical industry.
A:Glass is a good electrical insulator because the electrons in the glass are tightly bound to the atoms and do not transfer easily, thus keeping electricity from moving through the glass. Conversely, good electrical conductors contain electrons that move freely.
A:The main difference between porcelain and ceramic tile is that porcelain tile is that it is denser and less porous than ceramic tile. Porcelain tile can be used both indoors and outdoors due to its durability. Ceramic tiles are only recommended for interior walls and floors. If the area has a lot of traffic, porcelain tile should be used.
A:Manually buffing the scratch with a wool polishing pad can remove scratches from glass; using an electric buffer on medium speed is also an option. Buffing is done with cerium oxide or jeweler's rouge. Manual buffing requires gentle motions and rubbing against the scratch to avoid breaking the glass.