To cut a 90-degree angle on crown molding using a compound miter saw, simply hold the molding on the saw bed upside down. Cut at the same angle as the shape of the wall's corner.Continue Reading
Place the molding on the saw bed upside down and backward. Put the bottom of the molding face-up to make a left corner cut. Most of the molding sits to the right of the saw.
Turn the blade 45 degrees to the right. Turn on the saw. Carefully saw off about 4 inches from the end of the molding at this 45-degree angle. Set the molding against the corner to check that the angle is flush against the wall.
Turn the other piece of molding upside down on the saw bed. Adjust the bottom of the molding so that it is face-up. Most of the molding sits to the left of the saw.
Turn the blade 45 degrees to the left. Turn on the saw. Saw off about 4 inches from the end of the molding. Hold the finished cut flush against the wall. Place it next to the previous molding cut to check that the corners fit together.
To cut crown molding corners, first put the molding upside down in a miter box, making sure it is braced on the back and side of the box, and then cut the molding at a 45-degree angle with a hand saw. This method works for inside and outside corners, but the top part should be shorter for inside corners and the bottom part should be shorter for outside corners.Full Answer >
In order to cut crown molding into angles, first place the molding in a miter box upside down with the molding against the sides and bottom of the box like it is against the ceiling and wall. Cut a 45-degree angle into the molding using a hand saw.Full Answer >
Cut crown molding by clamping a piece upright to a miter saw and cutting. The timing of this project depends on the amount of crown molding you need to cut. You need a power miter saw, crown molding, a cleat and a clamp.Full Answer >
To frame a bathroom mirror, cut molding or casing to match the mirror, cut 45-degree miters on each end using a miter saw, join the pieces with construction adhesive, and attach the frame to the outer edges of the mirror with the same adhesive. If desired, fill the gap around the edge of the frame with caulking.Full Answer >