Q:

What allows air to enter the lines of a well water system?

A:

Quick Answer

Air finds its way into a water pump through many avenues, but the most common reason is improperly priming the system during installation. Another common source of vapor ending up in water lines is due to the presence of methane gas within the well itself. While not harmful at these levels, it can cause the water lines to sputter.

Continue Reading

Full Answer

Sputtering water lines are probably a minor concern when a home's water smells of methane gas. When methane is in the system, the water intake line for a pump can become damaged, which leads small gaps or holes to form. This allows water to leak out and air to seep in.

Each of these scenarios is a fairly common problem that professional well technicians come across on a regular basis. When they do eventually crop up, the most appropriate solution is to simply call in a professional to both diagnose and resolve the problem. Too often, homeowners relying on well water attempt to troubleshoot and resolve the issue themselves. This can create more problems than it addresses as the average person simply is not familiar with the system itself or the intricacies of plumbing. Unfortunately, most of the pump systems that the average homeowner is familiar with are either completely different or not used for such an extensive and long term purpose.

Learn more about Plumbing

Related Questions

  • Q:

    How do you troubleshoot water well problems with the pressure switch?

    A:

    The pressure switch to a well pump may shut down a well or cause the water not to flow, especially if both the switch and a pressure tank are affixed to the system. Both parts can cause an over-circulation of water, which, in turn, shuts down a system. The shut-off measure is a safeguard in case a pipe breaks while water is being pumped from the well.

    Full Answer >
    Filed Under:
  • Q:

    How do you read a diagram of a well pump system?

    A:

    To read a diagram of a well pump system, locate the two main components: the pump and the storage tank. Locate the pipes that connect the tank to the pump and the pump to the well. At the point where the top of the well meets the surface, locate the well seal. Many pump diagrams also have one or more expanded sections that show the interior pump components, including the pressure switch, the O ring and the controls.

    Full Answer >
    Filed Under:
  • Q:

    What are some troubleshooting ideas for a well pump?

    A:

    Troubleshooting ideas for a well pump include checking the electrical system, ensuring the structural integrity of individual pump components and verifying that the well's depth-to-water ratio is compatible with the pump. Another easy troubleshooting idea is to check the piping to ensure that air is not getting into the system.

    Full Answer >
    Filed Under:
  • Q:

    How do you treat well water with bleach?

    A:

    To treat well water with bleach, use a pump to clear the well of any dirty or cloudy water, and then add chlorine bleach to the well. This bleach is not found in the supermarket and must obtained from a professional who sells water treatment products.

    Full Answer >
    Filed Under:

Explore