Flame test

A flame test is a procedure used in chemistry to detect the presence of certain metal ions, based on each element's characteristic emission spectrum. The color of flames in general also depends on temperature; see flame color.

The test involves introducing a sample of the element or compound to a hot, non-luminous flame, and observing the color that results. Samples are usually held on a platinum wire cleaned repeatedly with hydrochloric acid to remove traces of previous analytes. Different flames should be tried to avoid wrong data due to "contaminated" flames, or occasionally to verify the accuracy of the color. In high-school chemistry courses, wooden splints are sometimes used, mostly because solutions can be dried onto them, and they are inexpensive. Nichrome wire is also sometimes used. When using a splint, one must be careful to wave the splint through the flame rather than holding it in the flame for extended periods, to avoid setting the splint itself on fire.

Sodium is a common component or contaminant in many compounds and its spectrum tends to dominate over others. The test flame is often viewed through cobalt blue glass to filter out the yellow of sodium and allow for easier viewing of other metal ions.

The flame test is fast and easy to perform, and does not require any equipment not usually found in a chemistry laboratory. However, the range of detected elements is small, and the test relies on the subjective experience of the experimenter rather than any objective measurements. The test has difficulty detecting small concentrations of some elements, while too strong a result may be produced for certain others, which tends to drown out weaker signals.

Although the test only gives qualitative information, not quantitative data about the actual proportion of elements in the sample; quantitative data can be obtained by the related techniques of flame photometry or flame emission spectroscopy. also when most of the chemicals are put in rubbing oil it makes a darker light.

Common metals

See also

• Colored fire
• Emission spectrum
• Qualitative inorganic analysis

References