Dual-tone multi-frequency (DTMF) signaling is used for telephone signaling over the line in the voice-frequency band to the call switching center. The version of DTMF used for telephone tone dialing is known by the trademarked term Touch-Tone (canceled March 13, 1984), and is standardized by ITU-T Recommendation Q.23. Other multi-frequency systems are used for signaling internal to the telephone network.
As a method of in-band signaling, DTMF tones were also used by cable television broadcasters to indicate the start and stop times of local commercial insertion points during station breaks for the benefit of cable companies. Until better out-of-band signaling equipment was developed in the 1990s, fast, unacknowledged, and loud DTMF tone sequences could be heard during the commercial breaks of cable channels in the United States and elsewhere.
Dual Tone Multi-Frequency, or DTMF, is a method for instructing a telephone switching system of the telephone number to be dialed, or to issue commands to switching systems or related telephony equipment.
The DTMF dialing system traces its roots to a technique developed by Bell Labs in the 1950s called MF (Multi-Frequency) which was deployed within the AT&T telephone network to direct calls between switching facilities using in-band signaling. In the early 1960s, a derivative technique was offered by AT&T through its Bell System telephone companies as a "modern" way for network customers to place calls. In AT&Ts Compatibility Bulletin No. 105, AT&T described the product as "a method for pushbutton signaling from customer stations using the voice transmission path."
The consumer product was marketed by AT&T under the registered trade name Touch-Tone. Other vendors of compatible telephone equipment called this same system "Tone" dialing or "DTMF," or used their own registered trade names such as the "Digitone" of Northern Electric (now known as Nortel Networks).
The DTMF system uses eight different frequency signals transmitted in pairs to represent sixteen different numbers, symbols and letters - as detailed below.
The U.S. military also used the letters, relabeled, in their now defunct Autovon phone system. Here they were used before dialing the phone in order to give some calls priority, cutting in over existing calls if need be. The idea was to allow important traffic to get through every time. The levels of priority available were Flash Override (A), Flash (B), Immediate (C), and Priority (D), with Flash Override being the highest priority. Pressing one of these keys gave your call priority, overriding other conversations on the network. Pressing C, Immediate, before dialing would make the switch first look for any free lines, and if all lines were in use, it would disconnect any non-priority calls, and then any priority calls. Flash Override will kick every other call off the trunks between the origin and destination. Consequently, it is limited to the White House Communications Agency. Precedence dialing is still done on the military phone networks, but using number combinations (Example:Entering 93 before a number is a priority call) rather than the separate tones and the Government Emergency Telecommunications Service has superseded Autovon for any civilian priority telco access.
Present-day uses of the A, B, C and D keys on telephone networks are few, and exclusive to network control. For example, the A key is used on some networks to cycle through different carriers at will (thereby listening in on calls). Their use is probably prohibited by most carriers. The A, B, C and D tones are used in amateur radio phone patch and repeater operations to allow, among other uses, control of the repeater while connected to an active phone line.
DTMF tones are also used by some cable television networks and radio networks to signal the local cable company/network station to insert a local advertisement or station identification. These tones were often heard during a station ID preceding a local ad insert. Previously, terrestrial television stations also used DTMF tones to shut off and turn on remote transmitters.
|1209 Hz||1336 Hz||1477 Hz||1633 Hz|
|Event||Low frequency||High frequency|
|Busy signal||480 Hz||620 Hz|
|Dial tone||350 Hz||440 Hz|
|Ringback tone (US)||440 Hz||480 Hz|
The tone frequencies, as defined by the Precise Tone Plan, are selected such that harmonics and intermodulation products will not cause an unreliable signal. No frequency is a multiple of another, the difference between any two frequencies does not equal any of the frequencies, and the sum of any two frequencies does not equal any of the frequencies. The frequencies were initially designed with a ratio of 21/19, which is slightly less than a whole tone. The frequencies may not vary more than ±1.8% from their nominal frequency, or the switching center will ignore the signal. The high frequencies may be the same volume or louder as the low frequencies when sent across the line. The loudness difference between the high and low frequencies can be as large as 3 decibels (dB) and is referred to as "twist." The minimum duration of the tone should be at least 70 msec, although in some countries and applications DTMF receivers must be able to reliably detect DTMF tones as short as 45ms.
DTMF can be decoded using the Goertzel algorithm.
Synonyms include multifrequency pulsing and multifrequency signaling.
Publication No. WO/2010/078773 Published on July 15, Assigned to Huawei Technologies for Dual Tone Multi-Frequency Digit Reporting Method, System, Media Gateway (Chinese Inventors)
Jul 15, 2010; GENEVA, July 19 -- Ning Zhu and Weiwei Yang, both of China, have developed a method, system, and media gateway for reporting dual...
WIPO PUBLISHES PATENT OF ZTE FOR "METHOD AND SYSTEM FOR TRANSMITTING OUT-OF-BAND DUAL-TONE MULTI-FREQUENCY SIGNAL ON MEDIA SURFACE" (CHINESE INVENTOR)
Dec 30, 2011; GENEVA, Dec. 30 -- Publication No. WO/2011/160345 was published on Dec. 29. Title of the invention: "METHOD AND SYSTEM FOR...
Publication No. WO/2009/079960 Published on July 2, Assigned to Huawei Technologies for Outband Dual Tone Multi-Frequency Signaling Method (Chinese Inventor)
Jul 04, 2009; GENEVA, July 4 -- Muqiang Xia, China, has developed a method for outband dual tone multi-frequency signaling. The patent has been...
Wipo Publishes Patent of Zte, Jian Pei, Honghe Wei and Bin Zhao for "Method and Apparatus for Sending Dual Tone Multi-Frequency Signal" (Chinese Inventors)
Apr 26, 2013; GENEVA, April 26 -- Publication No. WO/2013/056548 was published on April 25.Title of the invention: "METHOD AND APPARATUS FOR...
US Patent Issued to Research in Motion on Dec. 25 for "Method and Mobile Communication Device for Generating Dual-Tone Multi-Frequency (DTMF) Commands on a Mobile Communication Device Having a Touchscreen" (Canadian Inventors)
Jan 01, 2013; ALEXANDRIA, Va., jAN. 1 -- United States Patent no. 8,340,969, issued on Dec. 25, was assigned to Research In Motion LTD....