Direct Numerical Control
, also known as Distributed Numerical Control
, (both DNC) is a common manufacturing
term for networking CNC machine tools
. On some CNC machine controllers
, the available memory is too small to contain the machining program (for example machining complex surfaces), so in this case the program is stored in a separate computer and sent Direct
to the machine, one block at a time. If the computer is connected to a number of machines it can Distribute
programs to different machines as required. Usually, the manufacturer of the control provides suitable DNC software. However, if this provision is not possible, some software companies provide DNC applications that fulfill the purpose. DNC networking or DNC communication is always required when CAM
programs are to run on some CNC Machine control.
Programs had to be walked to NC controls, generally on paper tape. NC controls had paper tape readers precisely for this purpose. Many companies were still punching programs on paper tape well into the 1980s, more than twenty-five years after its elimination in the computer industry.
The focus in the 1980s was mainly on reliably transferring NC programs between a host computer and the control. The Host computers would frequently be Sun Microsystems
type computers running a variety of CAD/CAM software. DNC companies offered machine tool links using rugged proprietary terminals and networks. For example, DLog
offered an x86 based terminal, and NCPC
had one based on the 6809. The host software would be responsible for tracking and authorising NC program modifications. Depending on program size, for the first time operators had the opportunity to modify programs at the DNC terminal. No time was lost due to broken tapes, and if the software was correctly used, an operator running incorrect or out of date programs became a thing of the past.
Older controls frequently had no port capable of receiving programs such as an RS232 or RS422 connector. In these cases, a device known as a Behind The Reader or BTR card was used. The connection between the control's tape reader and the internal processor was interrupted by a microprocessor based device which emulated the paper tape reader's signals, but which had a serial port connected to the DNC system. As far as the control was concerned, it was receiving from the paper tape unit as it always had; in fact it was the BTR or Reader Emulation card which was transmitting. A switch was frequently added to permit the paper tape reader to be used as a backup.
1990s and beyond
The PC explosion in the late 1980s and early 1990s signalled the end of the road for proprietary DNC terminals. With some exceptions, CNC manufacturers began migrating to PC-based controls running DOS, Windows
which could be linked in to existing networks using standard protocols. Customers began migrating away from expensive minicomputer and workstation based CAD/CAM toward more cost-effective PC-based solutions. Users began to demand more from their DNC systems than secureTo remain competitive, therefore, DNC companies moved their offerings upmarket into DNC Networking, Shop Floor Control or SFC,
A challenge when interfacing into machine tools is that in some cases special protocols are used. Two well-known examples are Mazatrol and Heidenhain. Many DNC systems offer support for these protocols. Another protocol is DNC2 or LSV2 which is found on Fanuc controls. DNC2 allows advanced interchange of data with the control, such as tooling offsets, tool life information and machine status as well as automated transfer without operator intervention.
One of the issues involved in machine monitoring is whether or not it can be accomplished automatically. In the 1980s monitoring was typically done by having a menu on the DNC terminal where the operator had to manually indicate what was being done by selecting from a menu, which has obvious drawbacks. There have been advances in passive monitoring systems where the machine condition can be determined by hardware attached in such a way as not to interfere with machine operations (and potentially void warranties). Many modern controls allow external applications to query their status using a special protocol.
Smaller facilities will typically use a portable PC, palmtop or laptop to avoid the expense of a fully networked DNC system. In the past Facit Walk Disk and a similar device from Mazak were very popular.