Terrazzo workers create walkways, floors, patios, and panels by exposing marble chips and other fine aggregates on the surface of finished concrete or epoxy-resin. Much of the preliminary work of terrazzo workers is similar to that of cement masons. Marble-chip, cementitious terrazzo requires three layers of materials. First, cement masons or terrazzo workers build a solid, level concrete foundation that is 3 to 4 inches deep. After the forms are removed from the foundation, workers add a 1-inch layer of sandy concrete. Before this layer sets, terrazzo workers partially embed metal divider strips in the concrete wherever there is to be a joint or change of color in the terrazzo. For the final layer, terrazzo workers blend and place into each of the panels a fine marble chip mixture that may be color-pigmented. While the mixture is still wet, workers toss additional marble chips of various colors into each panel and roll a lightweight roller over the entire surface.
In the 1970s, polymer-based terrazzo was introduced and is called thin-set terrazzo. Initially polyester and vinyl ester resins were used as the binder resin. Today, most of the terrazzo installed is epoxy terrazzo. The advantages of this material over cementitious terrazzo include: wider selection of colors, 1/4 inch to 3/8 inch installation thickness, lighter weight, faster installation, impermeable finish, higher strength, and less susceptibility to cracking. In addition to marble aggregate blends, other aggregates have been used such as recycled glass, metal shapes and medallions.
When the terrazzo is thoroughly dry (or cured in the case of thin-set terrazzo), helpers grind it with a terrazzo grinder, which is somewhat like a floor polisher, only much heavier. Slight depressions left by the grinding are filled with a matching grout material and hand-troweled for a smooth, uniform surface. Terrazzo workers then clean, polish, and seal the dry surface for a lustrous finish.
Newly-set Terrazzo will not look like marble unless it is wet. That's where the goat's milk comes in, acting as a sealer and preserving the wet and marble-like look.
Archaeologists use the word terrazzo to describe the floors of early neolithic buildings (PPN A and B, ca. 9.000-8.000 BC) in Western Asia, that are constructed of burnt lime and clay, colored red with ochre and polished. The embedded crushed limestone gives it a slightly mottled appearance. The use of fire to produce burnt lime, which was also used for the hafting of implements thus predates the use of pottery by almost a thousand years. In the early Neolithic settlement of Cayönü in eastern Turkey ca. 90 m² of terrazzo floors have been uncovered. The floors of the PPN B settlement of Nevali Cori measure about 80 m². They are 15 cm thick, and contain about 10-15 % lime.
These floors are almost impenetrable to moisture and very durable, but their construction involved a high input of energy. Gourdin and Kingery (1975) estimate that about 5 times the amount of wood is needed to produce the required amount of lime, but recent experiments by Affonso and Pernicka have shown that only the double amount is needed. But that would still amount to 4.5 metric tons of dry wood for the floors in Cayönü, in what is an only sparsely wooded environment today.
Maintaining terrazzo flooring: recently I received a call from an individual concerned about her terrazzo lobby. She said that no matter how much they stripped the floor, it retained a blotchy appearance. She was concerned she may have damaged the floor and would not be able to fix it.(Hard Floor Maintenance Opportunities)
Jan 01, 2009; On arrival I noticed the floor was in the process of being stripped, and some of the areas did look blotchy. One of the obvious...