Amplitude modulation of a carrier wave normally results in two mirror-image sidebands. The signal components above the carrier frequency constitute the upper sideband (USB) and those below the carrier frequency constitute the lower sideband (LSB). In conventional AM transmission, the carrier and both sidebands are present, sometimes called double sideband amplitude modulation (DSB-AM).
In some forms of AM the carrier may be removed, producing double sideband with suppressed carrier (DSB-SC). An example is the stereophonic difference (L-R) information transmitted in FM stereo broadcasting on a 38 kHz subcarrier. The receiver locally regenerates the subcarrier by doubling a special 19 kHz pilot tone, but in other DSB-SC systems the carrier may be regenerated directly from the sidebands by a Costas loop or squaring loop. This is common in digital transmission systems such as BPSK where the signal is continually present.
If part of one sideband and all of the other remain, it is called vestigial sideband, used mostly with television broadcasting, which would otherwise take up an unacceptable amount of bandwidth. Transmission in which only one sideband is transmitted is called single-sideband transmission or SSB. SSB is the predominant voice mode on HF radio. Since the sidebands are mirror images, which sideband is used is a matter of convention. In amateur radio, LSB is traditionally used below 10 MHz and USB is used above 10 MHz.
In SSB, the carrier is suppressed, significantly reducing the electrical power (by up to 12 dB) without affecting the information in the sideband. This makes for more efficient use of transmitter power and RF bandwidth, but a beat frequency oscillator must be used at the receiver to reconstitute the carrier. Another way to look at an SSB receiver is as an RF-to-audio frequency transposer: in USB mode, the dial frequency is subtracted from each radio frequency component to produce a corresponding audio component, while in LSB mode each incoming radio frequency component is subtracted from the dial frequency.
Sidebands can also interfere with adjacent channels. The part of the sideband that would overlap the neighboring channel must be suppressed by filters, before or after modulation (often both). In Broadcast band frequency modulation (FM), subcarriers above 75 kHz are limited to a small percentage of modulation and are prohibited above 99 kHz altogether to protect the ±75 kHz normal deviation and ±100 kHz channel boundaries. Amateur radio and public service FM transmitters generally utilize ±5 kHz deviation.
Patent Issued for Pseudo Dual-Port SRAM and a Shared Memory Switch Using Multiple Memory Banks and a Sideband Memory
Feb 20, 2013; A patent by the inventors Dama, Jonathan (Pasadena, CA); Lines, Andrew (Malibu, CA), filed on December 19, 2008, was cleared and...
US Patent Issued to University of Florida Research Foundation on March 8 for "System and Methods for Remote Sensing Using Double-Sideband Signals" (California, Florida Inventors)
Mar 10, 2011; ALEXANDRIA, Va., March 10 -- United States Patent no. 7,903,020, issued on March 8, was assigned to University of Florida...
Assessing Different Ultranarrowband Formats; This Analysis Shows That the Lower Sideband Is Most Critical to Maintaining Effective Data Rates and the Phase Information Needed in Advanced Phase-Modulation-Based Communications Formats
Aug 01, 2012; Byline: SHIKAI ZHANG Doctor/Researcher CONVENTIONAL MODULATION formats make use of upper and lower sidebands to send...