In computer storage
, a SCSI initiator
is the endpoint that initiates a SCSI
session, that is, sends a SCSI command. The initiator usually does not provide any logical unit numbers
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Typically, a computer
is an initiator and a data storage device
is a target. As in a client-server
architecture, an initiator is analogous to the client, and a target is analogous to the server. Each SCSI address (each identifier on a SCSI bus
) displays behavior of initiator, target, or (rarely) both at the same time. There is nothing in the SCSI protocol that prevents an initiator from acting as a target or vice versa.
SCSI initiators are sometimes wrongly called SCSI controllers. See the SCSI host adapter article for a more detailed description of initiator's operation.
terms are applicable not only to traditional parallel SCSI
, but also to Fibre Channel Protocol
, (in some sense) SATA
, and many other storage networking protocols.
Address versus port
In most of these protocols, an address (whether it is initiator or target) is roughly equivalent to physical device's port. The situation where a single physical port hosts multiple addresses, or where a single address is accessible from one device's multiple ports is not very common, as of 2008
. Even when using multipath I/O
to achieve fault tolerance
, the device driver
switches between different targets or initiators statically bound on physical ports, instead of sharing a static address between physical ports.