Definitions

# Gunter's chain

Gunter's chain is a measuring device used for land survey. It was designed and introduced in 1620 by English clergyman and mathematician Edmund Gunter (1581-1626) long before the development of the theodolite and other more sophisticated equipment, enabling plots of land to be accurately surveyed by triangulation, and plotted, for legal and commercial purposes. Today, the Gunter Chain's most famous legacy however is that it gave us the accurate length of the cricket pitch.

Gunter divided the chain into 100 links, marked off into groups of 10 by brass rings which simplified intermediate measurement. On the face of it, the dimensions make no sense: Each link is a fraction under 8 inches long; 10 links make slightly less than 6 feet, 8 inches and a full lenghth of 66 feet. In fact, he had made a brilliant synthesis of two incompatible systems, the traditional English land measurements, based on the number 4, and the newly introduced system of decimals based on the number 10.

"Gunter's chain allowed either method to be used. An acre measured 4,840 square yards in traditional units and 10 square chains in Gunter's system. Thus, if need be, the entire process of land measurement could be computer in decimalized chains and links, and then converted to acres by dividing the results by 10."

Good illustrations can be accessed at , and .

Richard Norwood used one in his 1633-1635 traverse of London to York. (See his book A Sea-Man’s Practice)

The method of surveying a field or other parcel of land was to determine corners and other significant locations, and then to measure the distance between them, taking two points at a time. The surveyor is assisted by a chainman. A ranging rod (usually a prominently coloured wooden pole) is placed in the ground at the destination point. Starting at the originating point the chain is laid out towards the ranging rod, and the surveyor then directs the chainman to make the chain perfectly straight and pointing directly at the ranging rod. Another ranging rod is put in the ground at the forward end of the chain, and the chain is moved forward so that its hind end is at that point, and the chain is extended again towards the destination point. This process is called ranging; it is repeated until the destination rod is reached, when the surveyor notes how many full lengths (chains) have been laid, and he can then directly read how many links (one-hundredth parts of the chain) are in the distance being measured.

The whole process is repeated for all the other pairs of points required, and it is a simple matter to make a scale diagram of the plot of land. The process is surprisingly accurate and requires only very low technology. A limitation is that the land must be level and continuous -- it is not physically practicable to range across large depressions or significant waterways, for example. The triangulation method requires that the land is plane (not varying significantly in slope).

The theodolite developed later enables accurate assessment of angles and surveying points over long distances became possible. The Gunter's chain was still in use for small surveys in the second half of the twentieth century. In the US, Public Lands survey plats are still published in the Chain unit to maintain the consistency of a two hundred year old database.

The chain as a unit of length of 66 feet and the link, one-hundredth of a chain, probably developed as a result of the introduction of Gunter's chain as the technique of surveying; but it is important not to confuse the two; Gunter's chain is the physical device used in the field.

## References

Search another word or see gunter's quadranton Dictionary | Thesaurus |Spanish