foot-candle

foot-candle

[foot-kan-dl]
foot-candle: see photometry.

A foot-candle (sometimes foot candle; abbreviated fc, lm/ft², or sometimes ft-c) is a non-SI unit of illuminance or light intensity widely used in photography, film, television, and the lighting industry.

The unit is defined as the amount of illumination the inside surface an imaginary 1-foot radius sphere would be receiving if there were a uniform point source of one candela in the exact center of the sphere. Alternatively, it can be defined as the illuminance on a 1-square foot surface of which there is a uniformly distributed flux of one lumen. This can be thought of as the amount of light that actually falls on a given surface. The foot-candle is equal to one lumen per square foot.

The SI derived unit of illuminance is the lux. One footcandle is equal to 10.76 lux, although in the lighting industry, typically this is approximated as 1 footcandle being equal to 10 lux.

In the lighting industry, footcandles are a common unit of measurement used to calculate adequate lighting levels of workspaces in buildings or outdoor spaces. Footcandles are also commonly used in the museum and gallery fields, where lighting levels must be carefully controlled to conserve light-sensitive objects such as prints, photographs, and paintings, the colors of which fade when exposed to bright light for a lengthy period.

In the motion picture cinematography field, incident light meters are used to measure the number of footcandles present, which are used to calculate the intensity of motion picture lights, allowing cinematographers to set up proper lighting-contrast ratios when filming.

Since light intensity is the primary factor in the photosynthesis of plants, horticulturalists often measure and discuss optimum intensity for various plants in foot-candles. Full, unobstructed sunlight has an intensity of approximately 10,000 fc. An overcast day will produce an intensity of around 1,000 fc. The intensity of light near a window can range from 100 to 5,000 fc, depending on the orientation of the window, time of year and latitude.

Foot-candles can be easily measured and calculated with the use of a (manual) camera equipped with a built-in light meter. With the film speed set to ASA 25 and the shutter speed set to 1/60th of a second, focus on a sheet of white paper placed in the area where intensity is to be measured. Adjust the f-stop for proper exposure. Each f-stop has an approximate corresponding foot-candle reading (see the table below).

Footcandle versus lux

One footcandle ≈ 10.764 lux. The footcandle (or lumen per square foot) is a non-SI unit of illuminance. Like the BTU, it is obsolete but it is still in fairly common use in the United States, particularly in construction-related engineering and in building codes. Because lux and footcandles are different units of the same quantity, it is perfectly valid to convert footcandles to lux and vice versa.

The name "footcandle" conveys "the illuminance cast on a surface by a one-candela source one foot away." As natural as this sounds, this style of name is now frowned upon, because the dimensional formula for the unit is not foot · candela, but lumens per square foot. Some sources do however note that the "lux" can be thought of as a "metre-candle" (i.e. the illuminance cast on a surface by a one-candela source one meter away). A source that is farther away casts less illumination than one that is close, so one lux is less illuminance than one footcandle. Since illuminance follows the inverse-square law, and since one foot = 0.3048 m, one lux = 0.30482 footcandle ≈ 1/10.764 footcandle.

In practical applications, as when measuring room illumination, it is very difficult to measure illuminance more accurately than ±10%, and for many purposes it is quite sufficient to think of one footcandle as about ten lux.

Advertising novelties

Small candles molded in the shape of a foot were distributed by General Electric during the 1960s as advertising novelties. These visual puns promoted GE's line of fluorescent lighting and were an intentional reference to the unit of light; the sole of the "foot" had a label reading "GE makes the difference in light!" These were functional candles, had wicks, and could be lit. They were not, of course "standard candles" nor did they deliver any calibrated amount of illuminance.

See also

External links

Search another word or see foot-candleon Dictionary | Thesaurus |Spanish
Copyright © 2014 Dictionary.com, LLC. All rights reserved.
  • Please Login or Sign Up to use the Recent Searches feature