To test whether a mineral or rock contains carbonate, strong acids, such as hydrochloric acid or sulfuric acid, can be added to it. If the sample does contain carbonate, it will fizz and produce carbon dioxide and water. Weak acids such as acetic acid will react, albeit less vigorously. All of the rocks/minerals mentioned above will react with acid. To test for calcium, prepare a platinum or nichrome wire and dip it into some hydrochloric acid. Then, dip the wire into some crushed sample to be tested. Place the wire in a Bunsen Flame, if calcium is presented in the sample, brick-red flame will be produced. If a sample gives positive results for both of the two tests above, it is calcium carbonate.
Calcium carbonate will react with water that is saturated with carbon dioxide to form the soluble calcium bicarbonate.
The vast majority of calcium carbonate used in industry is extracted by mining or quarrying. Pure calcium carbonate (e.g. for food or pharmaceutical use), can be produced from a pure quarried source (usually marble).
Alternatively, calcium oxide is prepared by calcining crude calcium carbonate. Water is added to give calcium hydroxide, and carbon dioxide is passed through this solution to precipitate the desired calcium carbonate, referred to in the industry as precipitated calcium carbonate (PCC):
Calcium carbonate is also used in the purification of iron from iron ore in a blast furnace. Calcium carbonate is calcined in situ to give calcium oxide, which forms a slag with various impurities present, and separates from the purified iron.
Calcium carbonate is also used in the oil industry in drilling fluids as a formation bridging and filtercake sealing agent and may also be used as a weighting material to increase the density of drilling fluids to control downhole pressures.
Calcium carbonate is widely used as an extender in paints, in particular matte emulsion paint where typically 30% by weight of the paint is either chalk or marble.
Calcium carbonate is also widely used as a filler in plastics. Some typical examples include around 15 to 20% loading of chalk in uPVC drain pipe, 5 to 15% loading of stearate coated chalk or marble in uPVC window profile. PVC cables can use calcium carbonate at loadings of up to 70 phr (parts per hundred parts of resin) to improve mechanical properties (tensile strength and elongation) and electrical properties (volume resistivity). Polypropylene compounds are often filled with calcium carbonate to increase rigidity, a requirement that becomes important at high use temperatures. It also routinely used as a filler in thermosetting resins (Sheet and Bulk moulding compounds) and has also been mixed with ABS, and other ingredients, to form some types of compression molded "clay" Poker chips.
Fine ground calcium carbonate is an essential ingredient in the microporous film used in babies' diapers and some building films as the pores are nucleated around the calcium carbonate particles during the manufacture of the film by biaxial stretching.
Calcium carbonate is also used in a wide range of trade and DIY adhesives, sealants, and decorating fillers. Ceramic tile adhesives typically contain 70 to 80% limestone. Decorating crack fillers contain similar levels of marble or dolomite. It is also mixed with putty in setting stained glass windows, and as a resist to prevent glass from sticking to kiln shelves when firing glazes and paints at high temperature.
Calcium carbonate is known as whiting in ceramics/glazing applications, where it is used as a common ingredient for many glazes in its white powdered form. When a glaze containing this material is fired in a kiln, the whiting acts as a flux material in the glaze.
In North America, calcium carbonate has begun to replace kaolin in the production of glossy paper. Europe has been practicing this as alkaline papermaking or acid-free papermaking for some decades. Carbonates are available in forms: ground calcium carbonate (GCC) or precipitated calcium carbonate (PCC). The latter has a very fine and controlled particle size, on the order of 2 micrometres in diameter, useful in coatings for paper.
Used in swimming pools as a pH corrector for maintaining alkalinity "buffer" to offset the acidic properties of the disinfectant agent.
Calcium carbonate is widely used medicinally as an inexpensive dietary calcium supplement or antacid. It may be used as a phosphate binder for the treatment of hyperphosphatemia (primarily in patients with chronic renal failure). It is also used in the pharmaceutical industry as an inert filler for tablets and other pharmaceuticals. Calcium carbonate is also used in homeopathy as one of the constitutional remedies. Excess calcium from supplements, fortified food and high-calcium diets, can cause the "milk alkali syndrome," which has serious toxicity and can be fatal. In 1915, Bertram Sippy introduced the "Sippy regimen" of hourly ingestion of milk and cream, and the gradual addition of eggs and cooked cereal, for 10 days, combined with alkaline powders, which provided symptomatic relief for peptic ulcer disease. Over the next several decades, the Sippy regimen resulted in renal failure, alkalosis, and hypercalemia, mostly in men with peptic ulcer disease. These adverse effects were reversed when the regimen stopped, but it was fatal in some patients with protracted vomiting. Milk alkali syndrome declined in men after effective treatments for peptic ulcer disease. But during the past 15 years, it has been reported in women taking calcium supplements above the recommended range of 1200 to 1500 mg daily, for prevention and treatment of osteoporosis, and is exacerbated by dehydration. Calcium has been added to over-the-counter products, which contributes to inadvertent excessive intake. Excessive calcium intake can lead to hypercalcemia, complications of which include vomiting, abdominal pain and altered mental status.
A form of food additive is designated as E170. It is used in some soy milk products as a source of dietary calcium; one study suggests that calcium carbonate might be bioavailable as the calcium in cow's milk.
In 1989, a researcher, Ken Simmons, introduced CaCO3 into the Whetstone Brook in Massachusetts. His hope was that the calcium carbonate would counter the acid in the stream from acid rain and save the trout that had ceased to spawn. Although his experiment was a success, it did increase the amounts of aluminium ions in the area of the brook that was not treated with the limestone. This shows that CaCO3 can be added to neutralize the effects of acid rain in river ecosystems. Currently calcium carbonate is used to neutralize acidic conditions in both soil and water.
|Equilibrium Pressure of CO2 over CaCO3|
|550 °C||0.055 kPa|
|587 °C||0.13 kPa|
|605 °C||0.31 kPa|
|680 °C||1.80 kPa|
|727 °C||5.9 kPa|
|748 °C||9.3 kPa|
|777 °C||14 kPa|
|800 °C||24 kPa|
|830 °C||34 kPa|
|852 °C||51 kPa|
|871 °C||72 kPa|
|881 °C||80 kPa|
|891 °C||91 kPa|
|898 °C||101 kPa|
|937 °C||179 kPa|
|1082 °C||901 kPa|
|1241 °C||3961 kPa|
At temperatures above 550 °C the equilibrium CO2 pressure begins to exceed the CO2 pressure in air. So above 550 °C, calcium carbonate begins to outgas CO2 into air. But in a charcoal fired kiln, the concentration of CO2 will be much higher than it is in air. Indeed if all the oxygen in the kiln is consumed in the fire, then the partial pressure of CO2 in the kiln can be as high as 20 kPa.
The table shows that this equilibrium pressure is not achieved until the temperature is nearly 800 °C. For the outgassing of CO2 from calcium carbonate to happen at an economically useful rate, the equilibrium pressure must significantly exceed the ambient pressure of CO2. And for it to happen rapidly, the equilibrium pressure must exceed total atmospheric pressure of 101 kPa, which happens at 898 °C.
| Calcium ion solubility as a function of|
CO2 partial pressure at 25 °C (Ksp = 4.47×10−9)
|10−12||12.0||5.19 × 10−3|
|10−10||11.3||1.12 × 10−3|
|10−8||10.7||2.55 × 10−4|
|10−6||9.83||1.20 × 10−4|
|10−4||8.62||3.16 × 10−4|
|3.5 × 10−4||8.27||4.70 × 10−4|
|10−3||7.96||6.62 × 10−4|
|10−2||7.30||1.42 × 10−3|
|10−1||6.63||3.05 × 10−3|
|1||5.96||6.58 × 10−3|
|10||5.30||1.42 × 10−2|
Calcium carbonate is poorly soluble in pure water (47 mg/L at normal atmospheric CO2 partial pressure as shown below).
The equilibrium of its solution is given by the equation (with dissolved calcium carbonate on the right):
|CaCO3 ⇋ Ca2+ + CO32–||Ksp = 3.7×10–9 to 8.7×10–9 at 25 °C|
where the solubility product for [Ca2+][CO32–] is given as anywhere from Ksp = 3.7×10–9 to Ksp = 8.7×10–9 at 25 °C, depending upon the data source. What the equation means is that the product of molar concentration of calcium ions (moles of dissolved Ca2+ per liter of solution) with the molar concentration of dissolved CO32– cannot exceed the value of Ksp. This seemingly simple solubility equation, however, must be taken along with the more complicated equilibrium of carbon dioxide with water (see carbonic acid). Some of the CO32– combines with H+ in the solution according to:
|HCO3– ⇋ H+ + CO32–||Ka2 = 5.61×10–11 at 25 °C|
Some of the HCO3– combines with H+ in solution according to:
|H2CO3 ⇋ H+ + HCO3–||Ka1 = 2.5×10–4 at 25 °C|
Some of the H2CO3 breaks up into water and dissolved carbon dioxide according to:
|H2O + CO2(dissolved) ⇋ H2CO3||Kh = 1.70×10–3 at 25 °C|
And dissolved carbon dioxide is in equilibrium with atmospheric carbon dioxide according to:
|where kH = 29.76 atm/(mol/L) at 25 °C (Henry constant), being the CO2 partial pressure.|
For ambient air, is around 3.5×10–4 atmospheres (or equivalently 35 Pa). The last equation above fixes the concentration of dissolved CO2 as a function of , independent of the concentration of dissolved CaCO3. At atmospheric partial pressure of CO2, dissolved CO2 concentration is 1.2×10–5 moles/liter. The equation before that fixes the concentration of H2CO3 as a function of [CO2]. For [CO2]=1.2×10–5, it results in [H2CO3]=2.0×10–8 moles per liter. When [H2CO3] is known, the remaining three equations together with
|H2O ⇋ H+ + OH–||K = 10–14 at 25 °C|
(which is true for all aqueous solutions), and the fact that the solution must be electrically neutral,
make it possible to solve simultaneously for the remaining five unknown concentrations (note that the above form of the neutrality equation is valid only if calcium carbonate has been put in contact with pure water or with a neutral pH solution; in the case where the origin water solvent pH is not neutral, the equation is modified).
The table on the right shows the result for [Ca2+] and [H+] (in the form of pH) as a function of ambient partial pressure of CO2 (Ksp = 4.47×10−9 has been taken for the calculation).
The effect of the latter is especially evident in day to day life of people who have hard water. Water in aquifers underground can be exposed to levels of CO2 much higher than atmospheric. As such water percolates through calcium carbonate rock, the CaCO3 dissolves according to the second trend. When that same water then emerges from the tap, in time it comes into equilibrium with CO2 levels in the air by outgassing its excess CO2. The calcium carbonate becomes less soluble as a result and the excess precipitates as lime scale. This same process is responsible for the formation of stalactites and stalagmites in limestone caves.
|[Ca2+]max (10-4mol/L or °f)||1590||635||253||101||40.0||15.9||6.35||4.70||2.53|
|Dissolved CaCO3 (g per liter of acid)||50.0||5.00||0.514||0.0849||0.0504||0.0474||0.0471||0.0470||0.0470|
where the initial state is the acid solution with no Ca2+ (not taking into account possible CO2 dissolution) and the final state is the solution with saturated Ca2+. For strong acid concentrations, all species have a negligible concentration in the final state with respect to Ca2+ and A− so that the neutrality equation reduces approximately to 2[Ca2+] = [A−] yielding . When the concentration decreases, [HCO3−] becomes non negligible so that the preceding expression is no longer valid. For vanishing acid concentrations, we recover the final pH and the solubility of CaCO3 in pure water.
|Dissolved CaCO3 (g per liter of acid)||49.5||4.99||0.513||0.0848||0.0504||0.0474||0.0471||0.0470||0.0470|
|Dissolved CaCO3 (g per liter of acid)||62.0||7.39||0.874||0.123||0.0536||0.0477||0.0471||0.0471||0.0470|
where [A] = [H3PO4] + [H2PO4−] + [HPO42−] + [PO43−] is the total acid concentration. We see that phosphoric acid is more efficient than a monoacid since at the final almost neutral pH, the second dissociated state concentration [HPO42−] is not negligible (see phosphoric acid ).
Wipo Publishes Patent of Universidad De Cadiz, Maria Jesus Mosquera Diaz, Juan Francisco Illescas Salinas for "Consolidating, Water-Repellent and Stain-Repellent Product for Carbonate Rocks and Other Construction Materials" (Spanish Inventors)
Oct 01, 2012; GENEVA, Oct. 1 -- Publication No. WO/2012/127079 was published on Sept. 27. Title of the invention: "CONSOLIDATING,...
Geology of carbonate reservoirs; the identification, description and characterization of hydrocarbon reservoirs in carbonate rocks.(Brief article)(Book review)
Dec 01, 2008; 9780470164914 Geology of carbonate reservoirs; the identification, description and characterization of hydrocarbon reservoirs in...
WIPO PUBLISHES PATENT OF BAKER HUGHES FOR "METHOD AND APPARATUS FOR PREDICTING PETROPHYSICAL PROPERTIES FROM NMR DATA IN CARBONATE ROCKS" (AMERICAN INVENTORS)
Mar 23, 2012; GENEVA, March 23 -- Publication No. WO/2012/037317 was published on March 22. Title of the invention: "METHOD AND APPARATUS FOR...