Decannulation is the permanent removal of a cannula (extubation), especially of a tracheostomy cannula.
Cannulae normally come with a trocar attached which allows puncturing of the body to get into the intended space. There are however 11 different kinds of cannulae: Bias Grind, Vet Point, Lancet Point, Deflected point (Anti-Coring), Pencil Point, Closed End Consistent Wall, Welded "Ball" End, Bullet Point, Razor Edge, Probe Point (Blunt End), and Trocar. Intravenous cannulae are the most common in hospital use. A variety of cannulae are used to establish cardiopulmonary bypass in cardiac surgery. Nasal cannula is a piece of plastic tubing which runs under the nose and is used to administer oxygen.
Complications may arise in the vein as a result of the cannulation procedure, the 4 main groups of complication are:
They are also a component used in the insertion of the Verichip.
During piercing, the fistula is created by inserting the needle. The needle is then removed, leaving the cannula in place, which is sometimes trimmed down. The cannula is then removed and sterile jewellery is inserted into the fistula simultaneously, in order to minimise trauma to the fresh fistula caused by insertion of blunt-ended jewellery.
In biological research, a push-pull cannula, which both withdraws and injects fluid, can be used to determine the effect of a certain chemical on a specific cell. The push part of the cannula is filled with a physiological solution plus the chemical of interest and is then injected slowly into the local cellular environment of a cell. The pull cannula then draws liquid from the extracellular medium, thus measuring the cellular response to the chemical of interest. This technique is especially used for neuroscience.
In general aviation, a cannula refers to a piece of plastic tubing which runs under the nose and is used to administer oxygen in non-pressurized aircraft flying above 10,000 feet above sea level in Canada and above 12,500 feet above sea level in the United States.
Air-sensitive cannulas:
1: Pressure in (gas in) 2: Pressure out (oil bubbler orange) 3: Higher flask with transfer liquid (yellow) to transfer 4: Lower receiving flask/transferred liquid (yellow)
5: Liquid transfer cannula 6: Septum (orange) on transfer flask 7: Septum (orange) on receiving flask 8: Pressure-control regulator/stopcock
9: Tubing/ gas-line (not shown for clarity, arrows show connectivity) 10: Gas cannula 11: 2-way syringe stopcock 12: Gas-tight syringe
13: Gas/pressure removed from flask 3 14: Gas/pressure added to flask 4
O = Open stopcock; X = Closed stopcock; black-arrow = Gas flow direction, orange arrow = Liquid flow direction