Ventilation/perfusion ratio

In respiratory physiology, the ventilation/perfusion ratio (or V/Q ratio) is a measurement used to assess the efficiency and adequacy of the matching of two variables:

• "V" - ventilation - the air which reaches the lungs
• "Q" - perfusion - the blood which reaches the lungs

These two variables constitute the main determinants of the blood oxygen concentration. In fact since V determines the quantity of oxygen mass reaching the alveoli per minute (g/min) and Q expresses the flow of blood in the lungs (l/min), the V/Q ratio refers to a concentration (g/l).

However actually the V/Q ratio is an adimensional measure since V is expressed as a flow too.

Physiology

Ideally, the oxygen provided via ventilation would be just enough to saturate the blood fully. In the typical adult, 1 liter of blood can hold about 200 mL of oxygen. Coincidentally, 1 liter of dry air has about 210 mL of oxygen. Therefore, under these conditions, the ideal ventilation perfusion ratio would be about 0.95. If one were to consider humidified air (with less oxygen), then the ideal v/q ratio would be in the vicinity of 1.0.

The actual values in the lung varies depending on the position within the lung. If taken as a whole, the typical value is approximately 0.8.

Because the lung is centered vertically around the heart, part of the lung is superior to the heart, and part is inferior. This has a major impact on the V/Q ratio:.

• apex of lung - higher
• base of lung - lower

In a subject standing in orthostatic position the apex of the lung shows higher V/Q ratio, while at the base of the lung the ratio is lower but nearer to the optimal value for reaching adequate blood oxygen concentrations. The main reason for lower V/Q ratios at the base is that both ventilation and perfusion increase when going from the apex to the base, but Q does it more strongly thus lowering the V/Q ratio. The principal factor involved in the genesis of V/Q dishomogeneity between the apex and the base of the lung is gravity (this is why V/Q ratios change in positions others than the orthostatic one).

Ventilation

Gravity and lung’s weight act on ventilation by increasing pleural pressure at the base (making it less negative) and thus reducing the alveolar volume. However at these smaller volumes the alveoli are more compliant (more distensible) and so capable of wider oxygen exchanges with the external environment. On the other side the apex, though showing a higher oxygen partial pressure, ventilates less efficiently since its compliance is lower and so smaller volumes are exchanged.

Perfusion

The impact of gravity on pulmonary perfusion expresses itself as the hydrostatic pressure of the blood passing through the branches of the pulmonary artery in order to reach the apical and basal district of the lung, acting respectively against or synergistically with the pressure developed by the right ventricle. Thus at the apex of the lung the resulting pressure can be insufficient for developing a flow (which can be sustained only by the negative pressure generated by venous flow towards the left atrium) or even for preventing the collapse of the vascular structures surrounding the alveoli, while the base of the lung shows an intense flow due to the higher resulting pressure.

The V/Q ratio can be measured with a ventilation/perfusion scan.

An area with no ventilation (and thus a V/Q of zero) is termed "shunt." An area with no perfusion (and thus a V/Q of infinity) is termed dead space.

References

External links

• Overview at anaesthesiauk.com
• RT Corner (Educational Site for RT's and Nurses) at rtcorner.net