The épée ('ep.eɪ) is the modern derivative of the original duelling sword, the rapier, used in sport fencing. Épée is French for "sword".
The weapon is similar to a foil (compared to a sabre), but has a stiffer blade that is V-shaped in cross-section, has a larger bell guard, and is heavier. The technique however, is somewhat different, as there are no rules regarding priority and right-of-way. In addition, the entire body area is a valid target area.
While modern sport fencing has three weapons (foil, épée, and sabre), each a separate event, épée is the only one in which the entire body is the valid target area. Épée is the heaviest of all fencing weapons.
In most higher-level competitions a grounded metal piste is used to prevent floor hits from registering as touches. Unlike sabre and foil, in épée there are no right-of-way rules regarding attacking; that is, touches are awarded solely on the basis of which fencer makes a touch first, according to the electronic scoring machines. Also, in épée double-touches are allowed, although the touches must be within 40 milliseconds (1/25th of a second) of each other.
The modern épée typically has a blade which measures 90 centimetres, and weighs up to 770 grams, although it sometimes weighs as little as 350 grams due to various metals and construction techniques. Only hits, or "touches", made with the push-button tip of the weapon are registered. The épée has a three sided blade, in contrast to the foil and saber, which have four and two sides respectively. In competitions a valid épée touch is scored if a fencer depresses their tip with 750g of pressure. Since the hand is a valid target, the bellguard is much larger than that of the foil and is most often made of aluminum or stainless steel. The tip is wired to a connector in the bellguard, then to an electronic scoring device or "box". The bellguard, blade, and handle of the épée are all grounded to the scoring box to prevent hits to the weapon from registering as touches. In the channel (blood groove) formed by the V-shaped blade, there are two thin wires leading from the far end of the blade to a connector in the bellguard. These wires are held in place with a strong glue that protects them from the rigors of an encounter. The amount of glue is kept to a minimum as in the unlikely (but possible) case that a fencer manages a touch in that glue, the touch would be registered on the electrical equipment, as the glue and blade are not earthed. But in the event of point to point and point to glue hits, a point should not be awarded. A "body wire" with a three-pronged plug at each end is placed underneath the fencer's clothing and attached to the connector in the bellguard, then to a wire leading to the scoring box. The scoring box signals with lights (one for each fencer) and a tone each time the tip is depressed. The tip of an épée comprises several parts including: the mushroom-shaped movable tip; its housing or "barrel" which is threaded to the blade; a contact spring; and a return spring. The tips are generally held in place by two small screws, called grub screws, which thread into the sides of the tip through elongated openings on either side of the barrel. The screws hold the tip within the barrel but are allowed to travel freely in the openings. While this is the most common system, screwless variations do exist. The return spring must allow the tip to support a weight of 750 grams without registering a touch. Finally, an épée tip must allow a shim of 1.5 mm to be inserted between the tip and the barrel, and when a 0.5 mm shim is inserted and the tip depressed, it should not register a touch. The contact spring is threaded in or out of the tip to adjust for this distance. These specifications are tested at the start of large competitions. During competitions, fencers are required to have a minimum of two weapons and two body wires in case of failure or breakage.
The épée is the heaviest of the three weapons (approaching the weight of an actual court sword). However, ultra-lightweight blades can actually reduce the weight of an épée to below that of a foil. On low-end weapons, the épée has a relatively stiff blade, though new technology has resulted in a flexible blade comparable to the other weapons. The épée is characterized by a V-shaped or approximately triangular cross-section , and a large round guard which offers much more protection to the hand than the foil guard.
In the pre-electric era, épéeists used a point d'arrêt ("stopping point"), a three-pronged point with small protruding spikes, which would snag on the opponent's clothing or mask, helping the referee to see the hits. The spikes caused épée fencing to be a notoriously painful affair, and épéeists could be easily recognized by the tears in their jacket sleeves. These days, the adherents of the point d'arrêt are few and far between, and non-electric weapons are generally fitted with foil-style buttons.
NOTE: These rankings are accurate as of August 5, 2008
http://www.britishfencing.com/British_Fencing.asp?PageID=183
NB First sentence of the FIE Sports Epee Rules is:
PART 3. EPEE
THE CONVENTIONS OF FENCING
METHOD OF MAKING A HIT
t.61. 1. The épée is a thrusting weapon only.
3 Discussion on the implications of Epee rule t.61. 1. can be found on a Yugoslav + English fencing forum at:
http://forum.mkfles.org.yu/viewforum.php?id=17
4 Reference to teaching children fencing footwork. Making learning fun for youngsters:
http://forum.mkfles.org.yu/viewtopic.php?id=65